Roper Parts

• Fridge too warm

Disconnected the old one from the defrost timer and reconnected the new one according to the numbers on each part. Read more

I ordered a pair of springs from AppliancePartsPros.com. When the new springs arrived, I unscrewed the frame from the counter top, slid the dishwasher out part of the way and installed the new springs and saved myself at least one-hundred dollars. Read more

I have a 25 year old Kenmore washer that works well and didn't want to get a new washer as they don't make them like they used to. Upon removing the top cap of the agitator and doing an inspection, the agitator dogs were completely broken into pieces. Due to age we decided to replace the lower and upper agitator along with the agitator auger dogs repair kit. All new parts and works fine. On inspection of old parts, we probably could have gotten away with just a $5 repair for the plastic... Read more

• No hot or cold water
• Will not stop filling with water
• Will not fill with water

Ordered this part and just changed it out. Not hard once I figured out how to get in to it. Read more

Replaced the motor and fan blade. Read more

I purchased a freezer gasket + key// from appliancepartspros.com //easy to order. I did not need to lock up my freezer but thought it might help the gasket seat (good thought). To replace gasket I started at top of door, wow, I should have started at bottom. Hated laying on my "belly" to screw in gasket. Ok, I am 77 years old but got the job done. All went okay until I had to close the door, the door would not stay shut. Key: I locked the door for a week. New seal is settling in, freezer is... Read more

• Light not working

We actually were able to determine that one of the freezer switches was bad and taped it down for about 3 days. The beeping stopped. Our fridge has two freezer switches and one fridge side switch. I ordered all three from these guys. They were cheaper than Whirlpool by about $20 for parts and about $15 for shipping. The part numbers had superseded too many times to count, usually that doesn't matter but in this case it did. The new parts were just slightly bigger than the old parts AND... Read more

I diagnosed the problem, identified faulty parts, and replaced those components. Read more

Your part was a perfect replacement. Fixed in 30 minutes. Read more

I noticed the floor around the dishwasher was starting to get wet and warp the wooden floor. The chopper had gotten out of line and had cut a pinhole into the sump housing and the dishwasher was leaking badly. It was quite easy to repair. Just unhook the drain hose and the wire connectors, twist off the turbidity sensor and waste motor, pull out the shims and the whole assemple comes up and out. The hardest part was pulling the motor off of the assembly, since I wasn't sure if I needed to... Read more

Looked up the part number for replacing the burner dgrates in the 465 gas oven owner / parts manual. Plugged in the number in your easy to use website. Read over a few FAQs on the part I was ordering that answered my question of yes this is for a set of four. That was very helpful by the way. Ordered the parts and two days later they arrived to my door step. Read more

Replaced Case Water Filter assembly DA81-05883A. Please read my post entirely before starting. I completed all the tasks that I could without having to disconnect the refrigerator since it was full of food. First I removed the panel on top of the refrigerator that covers the water line that feeds the dispenser. Do not disconnect any electrical connections or the water line at this time. Remove the panel from the back bottom of the refrigerator that covers the compressor and water valve,... Read more

Purchased the light lens and screwed it into the dryer drum. Read more

Bought a new upper agitator/filter housing. Just slide it over the bottom agitator housing and put the cap from the old one on the new one. Takes maybe 3 minutes to do. The screen inside the lower part of the housing/filter holds it snug to the bottom housing and does not fly off during the spin cycle. Works great. Read more

New valve. Read more

I replaced all 4 ignitors and new clips. Read more