Starter

This starter pulley kit is designed for use on string trimmers. It is made to spin the flywheel so the engine will start up when the starter rope is pulled. Sometimes, the teeth on the starter pulley can wear out with extended use. This can result in teeth that do not contact the pawls on the flywheel. In some cases, the pulley will also wear in the area where the recoil spring attaches. If the string trimmer's engine isn't starting, has trouble starting, or has a pull rope that won't retract, a starter pulley kit offers the replacement parts needed. Before the replacement of the part is done, the engine should be cool to the touch. The wire and boot should also be removed from the spark plug before replacement to prevent starting the engine. This is a genuine OEM component that comes directly from the manufacturer. It's designed for use on gas-powered string trimmers by Husqvarna, Craftsman, and Poulan. It is made of hard plastic and steel and comes with the recoil spring, drive pulley, rewind pulley, and drive spring. This is sold as an individual kit.

This is a starter solenoid used in a variety of riding lawn mowers and yard tractors. Unlike most push mowers that are started by pulling a rope and firing a magneto, riding mowers have starters and batteries. The solenoid is the link between the battery and starter. When the ignition key is turned, electricity from the starter flows through the solenoid to the mower's ignition, firing the engine. Because it is the part subjected to abrupt electrical charges, over time the solenoid's internal workings may fail and the device must be replaced. A symptom of a bad solenoid is the if the engine fails to turn over. To make sure the problem is not the battery, turn the ignition switch on and use a screwdriver to simultaneously touch both terminals of the solenoid. If the engine turns over, the solenoid must be replaced. The solenoid sits inside the engine housing by the starter motor. Before starting to replace it, disconnect the positive battery cable. Replacing this device is as simple as disconnecting the wires that attach it to the battery and unbolting it from the engine housing. This solenoid is a genuine OEM replacement part that is manufactured to be an exact replacement for the original part. This solenoid is compatible with Poulan, Husqvarna, Craftsman, and Weed Eater equipment.

The starter spring is what is used to create the recoil to start the engine on pull-start chainsaws, blowers, trimmers, and other lawn equipment. When the starter handle is pulled, the rope extends and pulls on the spring, causing it to tighten and then release, which creates the action to fire the motor. It may also be called the recoil spring, rewind spring, or return spring, but they all refer to the starter spring. Over time, this can become worn with use, and in some situations, it can even break completely. If the starter rope will not rewind into the housing, the spring may be twisted and need to be replaced. If so, this genuine OEM starter spring will do the job for compatible machines. This model is manufactured by Husqvarna and compatible with various Poulan and Husqvarna lawn equipment. This spring may serve as a replacement for many machines including blowers, hedge trimmers, grass trimmers, chain saws, and saws. Check the user manual for compatibility and fit, as well as part numbers. Be sure to install this according to all instructions and diagrams for safe and proper operation.

This is a starter assembly with a specific design for Husqvarna handheld backpack leaf blowers. It is the same component that is included in the blower that lets a user pull to start the engine. The starter is composed of several parts including a plastic housing, starter spring, starter pulley, and a pull rope with a grip. As time goes on, the parts of the starter assembly can start to wear out or become broken and will need to be replaced.The only tool needed to replace the starter assembly is a standard screwdriver. The leaf blower will have four screws that offer access to the starter assembly. Remove each of the screws and set them aside. Take out the old starter assembly, and the new component can be installed in its place. Reinstall the screws and ensure they are tightened before using the leaf blower again.This starter assembly is an authentic OEM replacement part that is sourced straight from the manufacturer. It is sold as an individual part. The starter assembly is made for use with leaf blowers manufactured by Husqvarna.

The starter pawl bridge provides the resistance for the starter rope that is required to fire the engine. The bridge connects to the flywheel and is responsible for making it spin when the starter rope is pulled. Over time, the pawl can become worn with use. In the event that other starter components go bad, those can also damage the pawl. If the flywheel does not engage, it may be a faulty pawl. Always use gloves when replacing engine components and be certain to disconnect the spark plug before working on any engine parts. This OEM starter pawl bridge is manufactured to exact standards and is made by Husqvarna. It is compatible with select Husqvarna and Jonsered trimmers. This durable replacement part is made of metal and sold individually.

This recoil starter spring is what retracts the rope back into the main starter assembly. When the rope is pulled, the spring expands. The release of the rope triggers a retraction, which pulls the rope in and activates the starter, creating the chain reaction that starts the engine. This spring can get twisted or become hyperextended with regular use, in which case the only solution would be to replace the entire spring assembly. This OEM recoil starter spring is manufactured by Husqvarna, with high-quality standards in mind. It is compatible with Poulan, Weed Eater, and Husqvarna machines, including trimmers, leaf blowers, edgers, and pruners. Owners should always consult their parts diagram or owner’s manual for exact part number compatibility. This durable metal spring is designed from high-quality materials and is sold individually. The starter rope and other parts of the assembly are sold separately. Always disconnect the spark plug and wear gloves when performing engine work.