Washer Panel Parts

Color: Almond.

Back panel for your washer. This structural panel covers and protects the rear of the cabinet. Replace if cracked, damaged, or missing.

This replacement back panel restores the appliance's rear enclosure to protect internal components and provide structural support. It helps keep wiring and electronics covered and reduces dust and debris entry. What it does:

• Covers and protects internal components, wiring and control assemblies from damage and contamination
• Restores cabinet rigidity for proper panel alignment and door/hinge support
• Prevents rattling or scraping caused by a bent, loose or missing rear panel
• Helps maintain proper airflow paths by closing the cabinet rear opening

• Disconnect power (unplug or switch off circuit breaker) before beginning any repair
• Use caution for sharp sheet-metal edges; wear gloves and eye protection
• Transfer and reuse any original mounting hardware; only use replacement fasteners specified by the manufacturer
• Verify panel orientation and alignment before tightening fasteners; check that no wiring is pinched

This cabinet front panel restores the refrigerator's exterior appearance and protects internal components from everyday wear. A factory-style replacement that keeps the door area looking clean and functioning properly. What it does:

• Replaces a dinged, cracked or discolored front cabinet surface
• Restores a flush, sealed exterior to help keep door components protected
• Helps eliminate visible cosmetic damage and improves appliance appearance
• Matches original mounting locations for a direct-replacement fit

• High-level replacement — remove power and empty door area before starting
• Handle and related trim may need removal to access mounting screws
• Retain all original fasteners; replace only with identical hardware when required

Front panel for your washer. Covers the front exterior of the machine. Replace if your panel is cracked, dented, scratched, or damaged.

Replacement front panel for your washer. Restores the exterior appearance when the original panel is cracked, dented, discolored, or damaged.

This back panel is the exact exterior rear housing piece for the appliance, restoring proper enclosure and finished appearance while protecting internal components. It fits the original mounting locations and maintains factory airflow paths. What it does:

• Replaces a cracked, dented, or corroded rear housing that exposes internal parts
• Protects internal components from dust, moisture, and accidental contact
• Restores proper alignment for rear trim and mounting points
• Helps maintain intended airflow and clearance behind the unit

• Disconnect power and water before beginning service.
• Handle panel edges carefully; metal edges may be sharp.
• Reuse original screws and clips unless damaged; torque to OEM recommendations.