Washer Panel Parts

Color: Lunar Silver

The Lid is an OEM part for Whirlpool washers. As the top cover, the lid seals in the water and allows the machine to properly wash clothes. It also protects internal components from dust and debris. 

Causes of a bad lid can include cracks, breaks or warping from extended use or accidental damage. Normal wear and tear over time can cause deterioration. 

Symptoms of a bad lid include:

• Water leaks around the lid during wash cycles 
• The lid does not close or seal properly
• Excessive noise from an ill-fitting or loose lid
• Dust or dirt inside the washer from an incomplete seal

This OEM Whirlpool replacement lid is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

This top decor cover replaces a worn or damaged stove/range front trim to restore the cooktop's appearance and protect underlying components. Designed to match factory finish and fit the original mounting points. What it does:

• Covers and protects the front edge of the cooktop surface from spills, grease, and cosmetic damage
• Restores the appliance's factory appearance after scratches, dents, or faded finish
• Helps direct spills away from controls and internal components
• Fits the original mounting locations for a secure, factory-like fit

• One top decor cover (color: white)

• Remove power to the appliance before beginning service to avoid shock or injury
• Basic hand tools typically required; keep track of fasteners during disassembly
• Reuse original screws and brackets unless damaged — replace if necessary

This top cover assembly replaces the appliance's damaged or worn top panel to restore a clean, finished appearance and protect the internal controls and wiring from debris. Fits the factory mounting points for a direct replacement. What it does:

• Covers and protects the control area, wiring and internal components from dust and spills
• Restores the appliance's exterior appearance when the original top is dented, cracked or rusted
• Provides the correct mounting surface for the control console and trim pieces
• Helps keep components properly shielded during normal use

• Disconnect power to the appliance before starting any work
• Remove the control console and screws securing the old top; handle edges carefully—they can be sharp
• Align the replacement top to factory mounting points and reattach hardware and any trim

This lid assembly kit replaces a damaged or broken top-load washer lid to restore a secure, flush cover and proper lid operation. Designed as a direct replacement to help the washer close and latch correctly. What it does:

• Replaces a cracked, warped or broken washer lid that no longer closes or stays shut
• Restores a proper fit and alignment so the lid can latch and allow normal cycle operation
• Prevents debris from entering the wash tub through a damaged opening
• Helps reduce noise and vibration caused by a loose or ill-fitting lid

• Disconnect power to the washer before starting any work
• Follow the manufacturer's service instructions and use appropriate tools for removal and installation
• Check lid alignment and latch engagement during installation to ensure proper operation
• If you find additional damaged parts (hinge, latch, strike), replace those components per OEM recommendations