Washer Wire, Harness, Power Cord

Motor control wire harness for washers. Connects the control board to the drive motor. Replace if wires are frayed, connectors are damaged, or harness is worn.

This wire harness assembly routes power and control signals between the appliance's components, restoring lost or intermittent electrical connections for reliable operation. It replaces damaged or burnt wiring and worn connector ends. What it does:

• Provides factory-style electrical connections between controls, motors, switches, and sensors
• Restores power and signal continuity when original wiring is frayed, cut, or corroded
• Helps stop intermittent operation, no-power conditions, or arcing caused by damaged wires or connectors
• Maintains correct wire routing and connector fit to prevent chafing and short circuits

• Disconnect power (unplug or shut off breaker) before starting any repair
• Compare the new harness to the original to ensure connector types and lengths before installing
• Route wires along original clips and channels; avoid contact with sharp edges or hot surfaces
• If connectors are corroded or damaged, replace them rather than splicing; follow OEM instructions

Wire harness that connects the washer motor to the control system. Replace if wires are frayed, connectors are damaged, or harness is broken or worn.

This ground wire restores the appliance's chassis grounding connection so metal parts are properly bonded to earth ground for safer operation and correct electrical performance. What it does:

• Provides the chassis-to-ground connection that completes the appliance's safety grounding path
• Helps stop stray voltage on metal panels and reduces risk from loose or missing ground connections
• Common service item when a wire is frayed, detached, or shows burned/corroded terminals
• Replaced when continuity checks fail or grounding screws/terminals are damaged

• Disconnect all power (unplug or switch off breaker) before accessing wiring
• Verify grounding continuity with a multimeter after installation
• Use correct fasteners and secure both ends under their original terminals; avoid over-tightening