Whirlpool Control Board

Fix a cracked, faded, or missing control panel trim on your compactor. This flat console kit restores the finished appearance and protects controls.

Fix a washer that won't start, advance cycles, or respond to controls. This electronic control board restores normal operation in about 1 hour.

Fix a washer that won't start the wash cycle or has unresponsive controls. This electronic control board manages cycle selection and timing functions.

Fix a dryer that won't start, won't heat, or won't advance cycles. This timer controls drying programs and cycle progression. Moderate DIY repair.

This refrigerator ice level control board monitors ice production and storage levels in your automatic ice maker. It signals when to stop making ice when the bin is full and resume production when ice is needed. Replace this control board when your ice maker overproduces ice, fails to stop when full, or doesn't restart ice production when the bin empties.

This replacement insert restores a finished appearance and secures a panel or trim opening on compatible appliances. It helps cover gaps and provides a clean, stable mounting surface so doors and panels sit correctly. What it does:

• Covers and finishes an opening in a control panel, door, or trim area
• Helps hold adjacent panels or components in proper alignment
• Prevents exposed edges and reduces dirt accumulation in the opening
• Common symptom: missing, cracked, or loose insert that leaves a visible gap or allows panel movement

• One replacement insert

• Disconnect power to the appliance before beginning any work
• Remove the affected panel or access trim per the appliance service instructions
• Insert typically snaps or slides into place; verify alignment before fastening
• Reinstall panels and restore power; test that adjacent components operate and align correctly

If your washer won't start, stops mid-cycle, or displays error codes, the electronic control board may have failed. This replacement part restores function.

Range won't turn on or display shows nothing? The control board regulates temperature, timers, and heating elements. Requires multimeter testing.

Dishwasher won't start, lights blinking, or cycles not completing? The electronic control board manages all wash functions. Moderate DIY repair.

Dishwasher won't start or lights flashing? The electronic control board manages cycles and timing. Moderate DIY repair restores full operation.

Fix an oven that shuts off randomly, won't start, or shows error codes. This electronic control board manages heating cycles and user inputs.

Washer stuck between cycles or skipping rinse? This timer controls cycle sequence and duration. DIY repair typically takes 10-15 minutes with basic tools.

Refrigerator not defrosting or icing up excessively? A failed defrost timer won't cycle between cooling and defrost modes. Moderately easy repair restores function.

This Electronic Control Board is the appliance's central control module. It interprets inputs from sensors and switches and directs power to motors, valves, heaters, and fans to run cycles reliably when the original board has failed.

• Manages overall operation by processing signals and executing programmed cycles
• Sends power/commands to components such as motors, pumps, fans, heaters, and valves
• Typical symptoms of a failed board: no power or won't start, unresponsive controls, cycles that won't advance, intermittent shutdowns, or error codes
• Useful when diagnostics point to control failure after ruling out fuses, switches, sensors, and wiring

• Disconnect power before servicing; turn off water supply if applicable
• Use ESD protection and handle the board by its edges
• Photograph/label all connectors; move harnesses one at a time and transfer any jumpers/settings from the old board if present
• Mount securely, reconnect wiring, reassemble, then run the unit's diagnostic/self-test per the service manual

This is a stainless steel overlay insert that covers the front control panel area of a trash compactor. It provides the finished exterior surface around the control buttons and gives the unit a clean, built-in appearance. Replace this insert if it is scratched, dented, discolored, or if the original panel overlay has become damaged or is peeling.

Fix a dishwasher that won't cycle, stays in wash mode, or has unresponsive controls. This control board manages timing and operation. Moderate DIY repair.