Need Help?
Call
Fix washer won't start, stops mid-cycle, or skips rinse with this electronic control board. Moderate DIY repair with connector-based installation.
Fixes refrigerator displays flashing, unit cycling on/off, or fans not running. This power supply board converts AC to DC for controls and components.
Replaced the main circuit board, evaporator fan motor, and power supply. Probably did not need to change the power supply but did so just to be safe. Replaced the fan motor because I was advised it could be the cause of the circuit board failure. Got a rebuilt main circuit from Circuit Board Medic because new ones are no longer available. Read more
Fix a washer stuck on rinse or spin cycle with this electronic control board. Restores responsive controls and accurate cycle timing. Moderate DIY repair.
Replaced electronic control board Read more
Fix a dishwasher that won't start cycles, has display issues, or heating problems. This main control board manages timing and functions. DIY install.
We tried replacing the pump. That didn't work. We then replaced the control board & that fixed the problem. Read more
Fixes refrigerator not cooling or freezing caused by failed compressor inverter. Restores variable-speed compressor operation and consistent temperatures.
Replaced compressor control unit. Read more
This is a temperature control switch used in a warming drawer to regulate the heat setting. It allows the user to select and maintain the desired warming temperature. Replace this switch if the warming drawer does not heat, stays on one temperature regardless of the setting, or does not respond when the control is adjusted.
Fix a washer that won't advance cycles, stops mid-cycle, or skips spin. This timer controls cycle progression and duration. Moderate DIY repair.
Changed timer, changed clutch band and drive as long as I was there. Then found lid switch in bad shape so I changed that also. Read more
Buttons not responding or control panel damaged? This dishwasher control panel housing secures and protects the interface. DIY-friendly, installs in 10-30 minutes.
Replaced the Housing interface and the control panel. Took less than 30 minutes Read more
Color: White
Buttons on trash compactor stopped working. It gets used a lot. So not the first time, so I took it apart and fixed it myself. Read more
Fix a microwave that won't heat or heats slowly by replacing the inverter board. This repair requires 1-2 hours and moderate skill to access.
Opened case and located burned component by visual inspection and tracing smell. Ordered a new inverter board with two-day delivery. It was very difficult to remove the old board install the new board. Function restored. Read more
This electromechanical timer controls the appliance's cycle sequencing so wash/dry cycles advance and complete as expected. Replacing a faulty timer restores proper cycle timing and program changes for consistent operation. What it does:
We found the part on the appliance parts pros.com and ordered it. The part arrived two days later and the dryer was operational within 15 minutes. We are very satisfied and will use the website in the future. Read more
Fix a cracked, faded, or missing control panel trim on your compactor. This flat console kit restores the finished appearance and protects controls.
Fix a washer that won't start, advance cycles, or respond to controls. This electronic control board restores normal operation in about 1 hour.
Fix a washer that won't start the wash cycle or has unresponsive controls. This electronic control board manages cycle selection and timing functions.
Replaced the electronic control panel Read more
Fix a dryer that won't start, won't heat, or won't advance cycles. This timer controls drying programs and cycle progression. Moderate DIY repair.
Looking through the small sight window at the front bottom left, I saw the igniter glow orange and the blue gas flame come on. After about 1 minute, the flame went out. After another couple of minutes, the cycle would happen again. Sometimes the igniter would not come on at all. I took the front off the dryer and checked continuity on the igniter, flame sensor, and coils that operate the gas valve. All were ok. So I thought one of the safety switches was probably bad. I put the front of the... Read more
Replaced with a part ordered from Appliance Parts Pros and had appliance repairman install. Read more
By continuing to use our site, you agree to our Terms of Usage and Privacy Policy. You can learn more about how we use cookies by reviewing our Privacy Policy.
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.