Whirlpool Gasket & Seal

The Seal is an OEM part for Whirlpool washing machines. This part provides a tight seal around the washer shaft, preventing water from leaking out of the tub during the wash cycle.

Causes of a bad shaft seal can include wear and tear over time, exposure to harsh detergents or cleaning agents, or damage from foreign objects that may have gotten into the washer. 

Symptoms of a bad shaft seal include:

• Water leaking from the bottom of the washing machine
• Excessive noise during operation
• Visible damage or wear on the seal
• Wet spots or puddles under the washer

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

The Tub Gasket is an OEM part for Whirlpool dishwashers. It seals the space between the washer tub and the surrounding door frame to prevent leaks. During wash cycles, water, heat, and detergent can degrade this rubber gasket material over time.

Causes of a bad tub gasket include cracks, compression, or perforations from years of expansion and contraction during wash cycles. Food debris or minerals caught in the channel may also inhibit proper sealing.

Symptoms of a defective tub gasket are:

• Puddles or standing water inside or outside the dishwasher
• Water leaks visible around the tub and door framework
• Wet floors after extended use

This OEM replacement gasket is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore dishwashers. 

The Tub Inlet Gasket is an OEM part for Whirlpool dishwashers. It ensures a watertight seal at the point where water enters the tub, preventing leaks and maintaining efficient water flow during the wash cycle.

Causes of a bad tub inlet gasket include wear and tear from regular use, damage from harsh cleaning chemicals, or drying out and cracking due to age.  

Symptoms of a bad tub inlet gasket include:

• Water leaking from the front or bottom of the dishwasher
• Poor cleaning results due to insufficient water pressure
• Visible cracks or wear on the gasket
• Unusual noises from the dishwasher during the filling cycle

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This door gasket runs around the perimeter of the door opening to create a dependable seal when closed. A proper seal helps limit air and moisture leaks, supporting stable internal conditions, reduced condensation, and efficient performance. What it does:

• Seals the door perimeter to block unwanted air and moisture infiltration
• Helps minimize condensation around the door and maintain consistent internal conditions
• Replaces gaskets that are torn, cracked, warped, or permanently compressed
• Can help when the door won't seal properly or you notice drafts, moisture, or temperature swings

• 1 door gasket

• Disconnect power if removing the door or working near electrical components
• Warm the gasket (soak in warm water or use low heat) to relax it before installation
• Press the gasket fully into the channel/retainer, ensuring corners are completely seated
• Check for uniform contact all around; adjust door alignment if needed and allow up to 24 hours for the gasket to conform

The Freezer Door Gasket is an OEM part for Whirlpool freezers. This gasket forms a tight seal around the freezer door, keeping the cold air inside and preventing warm air from entering, which helps to maintain the optimal temperature and efficiency of the freezer. The gasket measures approximately 20.19” x 31.29” Color: Misty Beige. For Black order 217731

Causes of a bad door gasket can include regular wear and tear, exposure to extreme temperatures, mold or mildew buildup, and physical damage from repeated opening and closing of the door. 

Symptoms of a bad freezer door gasket include:

• Frost buildup inside the freezer
• The freezer running more frequently to maintain temperature
• Difficulty keeping the door closed or it not sealing properly
• Visible cracks, tears, or deformation in the gasket

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

The Door Gasket is an OEM part for Whirlpool refrigerators. This gasket forms an airtight seal around the refrigerator or freezer door, preventing warm air from entering and cold air from escaping.  

Causes of a bad door gasket can include wear and tear from frequent opening and closing, exposure to temperature fluctuations causing the material to become brittle or warped, and damage from improper cleaning or handling.  

Symptoms of a bad door gasket include:

• The refrigerator door not sealing properly
• Visible cracks, tears, or deformities in the gasket
• Condensation or frost buildup around the door edges
• Increased energy consumption and poor cooling performance

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

This Door Seal replaces the perimeter gasket on the appliance door so it closes snugly and maintains a proper barrier during operation. A fresh seal supports performance and helps reduce heat and moisture escaping around the door edge.

• Creates a continuous barrier between the door and front frame
• Helps maintain proper door fit and latching
• Replaces a torn, warped, or brittle seal that can cause leaks or a loose-feeling door
• Common symptoms include visible gaps, escaping steam/heat at the door, or needing extra force to close

• Disconnect power at the breaker before servicing; allow the unit to cool completely
• Open the door and remove any retaining trim/fasteners to release the old seal; avoid bending the door
• Clean the channel and press the new seal fully into place, ensuring an even, continuous fit around the perimeter

The Front Bellow Tub Seal is an OEM replacement part for Whirlpool washing machines. Located behind the washer door opening, it forms a barrier sealing in moisture. The flexible seal compresses tightly against the tub during rotation to prevent water escape through potential seam gaps. 

Causes relate to years of compression from tub movement stressing the material. Mineral buildup prohibiting a flush seal also diminishes its functionality over time.

Symptoms of failure include:

• Water puddling outside the washer around the opening
• Mineral deposits accumulating hints at compromised sealing
• Leakage necessitates replacing the seal to regain integrity

Main seal between the front bulkhead and the outer tub for Whirlpool-made front load washers (Whirlpool, Kenmore Elite, KitchenAid). Clamps are not included. If clamps are needed, order WP8182210 and W10902779.

This is a genuine Whirlpool OEM replacement this part is also compatible with Maytag, Jenn-Air and some Kenmore models.

The Oven Door Seal is an OEM part for Whirlpool ovens. This seal is crucial for maintaining the oven’s efficiency by creating an airtight seal around the door, preventing heat from escaping during cooking. It helps ensure that the oven maintains the correct temperature, which is essential for even cooking and energy efficiency.

Common causes of a bad oven door seal include wear and tear from regular use, exposure to high temperatures, and damage from cleaning or handling.

Symptoms of a bad oven door seal include:

• Heat escaping from around the oven door
• Longer cooking times or uneven cooking
• The oven door not closing properly
• Visible cracks, tears, or deformation in the seal

This OEM part is also compatible with some Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Deflector is an OEM replacement part for Whirlpool dishwashers. Located in the lower corners of the tub, this component works to prevent leaks by keeping water from entering the cracks along the tub edges.

Causes of a bad corner deflector can include cracks, chips, or breaks from repeated impact or stress over time. Mineral buildup can also cause deflectors to warp or become misshapen, reducing their effectiveness.

Symptoms of a bad corner deflector include:

• Water leaks or moisture inside the cabinet below the dishwasher
• Puddles or drips near tub corners after cycles
• Mineral residue or pooling in lower tub corners

Replacing the corner deflector with a new OEM part restores a tight seal to prevent water from entering cracks and causing leaks or damaged components inside the cabinet.

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Gasket is an OEM part for Whirlpool refrigerators. This gasket is designed to create an airtight seal around the refrigerator or freezer door, preventing warm air from entering and cold air from escaping. It helps maintain the internal temperature, ensuring efficient operation and food preservation.

Causes of a bad gasket can include wear and tear over time, damage from frequent opening and closing of the door, or buildup of dirt and grime that compromises the seal.

Symptoms of a bad gasket include:

• The door not sealing properly
• Increased frost buildup in the freezer
• Higher energy bills due to the refrigerator working harder
• Condensation or moisture around the door seal

This OEM part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

The Door Gasket is an OEM part for Whirlpool refrigerators and freezers. This part forms an airtight seal around the refrigerator or freezer door, preventing warm air from entering and cold air from escaping. 

Causes of a bad door gasket can include general wear and tear, exposure to fluctuating temperatures, or physical damage from frequent door openings and closings. 

Symptoms of a bad door gasket include:

• Warm air leaking into the refrigerator or freezer
• Increased energy consumption
• Frost buildup around the door edges
• Refrigerator running more frequently to maintain temperature
• Visible cracks, tears, or deformation in the gasket

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

Color: Grey

Color: White

Color: Grey

The Balance Ring Adapter is an OEM part for Whirlpool washing machines. This part helps stabilize the washer drum during the spin cycle, ensuring smooth and balanced operation. This adapter connects the balance ring to the drum, helping to distribute weight evenly and reduce vibrations and noise.

Causes of a bad Balance Ring Adapter can include wear and tear from regular use, physical damage from overloading the washer, or degradation over time due to constant movement and stress.

Symptoms of a bad Balance Ring Adapter include:

• Excessive vibrations or shaking during the spin cycle
• Loud banging or thumping noises coming from the washer
• The washer moving or "walking" during operation
• Imbalance errors or the washer stopping mid-cycle due to uneven weight distribution

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.