Dishwasher Hose Or Tube

Dishwasher drain hose kit connects the dishwasher pump to your home's drain system. Replace if cracked, leaking, or damaged. Includes clamp.

Size: 6 foot long. Washers not included. This is one hose, for a set with washers order 285363. For inlet hose screen use 285452A and for inlet hose washers use 285448A

This installation kit includes the water supply line and fittings needed to connect a dishwasher to your home's water supply. It is used during initial dishwasher installation or when replacing a damaged or leaking supply line. Replace this kit if you notice water leaking at the connection point or if the existing supply line shows signs of wear or corrosion.

Prevents backflow from sink into dishwasher drain line. Replace if cracked, leaking, or missing. Installs at sink edge to create air break.

Water fill hose for dishwashers. Connects water supply to the tub inlet valve. Replace if cracked, leaking, kinked, or damaged to restore proper fill.

This kit includes a 10-foot braided fill hose used to connect a dishwasher's water inlet to the household water supply. It provides a reliable, leak-resistant connection during new installations or when replacing a damaged supply line. Replace this hose if you notice water leaking at the connection point, visible cracks, or bulging in the existing hose.

Dishwasher air gap with chrome cap installs on your sink. Replaces cracked, leaking, or missing anti-siphon devices to prevent water backflow.

This replacement fill hose carries incoming water from the washer's inlet valve to the tub or dispenser, restoring proper water delivery and preventing leaks. Use when the original hose is cracked, split, or leaking. What it does:

• Channels water from the inlet valve to the washer tub or dispenser during fill cycles
• Prevents leaks and drips caused by damaged or brittle hose material
• Restores proper fill behavior when a worn hose causes slow or no fill
• Works with the washer's inlet fittings and clamps to maintain a sealed connection

• Disconnect power and shut off the water supply before starting work
• Inspect and replace clamps or O-rings if worn; tight, corrosion-free connections help prevent leaks
• Route the hose to avoid kinks and pinching; secure with existing clips or ties
• After installation, restore water and power, then run a short fill cycle and check for leaks

Drain hose assembly that connects your dishwasher pump to the drain system. Replace if cracked, leaking, kinked, or disconnected from the pump fitting.

Replaces cracked, leaking, or worn drain hoses in your dishwasher. Creates the required elevated loop to prevent backflow. Essential for proper drainage.

The Hose is an OEM part for Whirlpool dishwashers. It connects the dishwasher pump and sump, functioning to drain and recirculate water throughout cycles.

Causes of failure can include mineral buildup inside the hose, splitting, and cracking of the lining from continuous heat and pressure usage over time.

Symptoms of a bad pump to sump hose include:

• Inadequate drainage and water removal from cycles
• Standing water left in the bottom of the dishwasher tub
• Leaks developing from hose connections at the pump or sump area

This genuine OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore models.

Drain hose connects your dishwasher drain pump to household plumbing. Replace if cracked, kinked, clogged with grease, or leaking during drain cycles.

Water distribution manifold for dishwashers. Delivers water from inlet valve to spray arms. Replace if cracked, broken, or leaking to restore proper flow.

Drain hose assembly carries wastewater from your dishwasher to the drain. Replace if cracked, leaking, kinked, or damaged to restore proper drainage.