Dryer Heating Element

Dryer not heating or producing insufficient heat? This heating element assembly distributes heat throughout the drum. Requires front panel removal to install.

This heater element kit is the replacement heating assembly for select GE electric dryers. It restores the dryer's ability to generate heat so loads dry normally and cycles finish on time. What it does:

• Generates the hot air needed to dry clothes by heating incoming air in the dryer cabinet
• Replaces a failed or damaged heating assembly that can cause no heat or reduced heat
• Helps resolve symptoms such as long dry times, damp clothes after a full cycle, or a dryer that runs but produces little or no heat
• Works with the dryer's thermal controls to maintain safe operating temperature

• Disconnect power at the breaker or fuse panel before starting work
• Allow the appliance to cool and handle the element carefully; avoid bending heating coils
• Follow the dryer's wiring diagram and parts diagram for correct placement and connections

Dryer not heating or taking too long to dry? This heating element restores proper heat generation. Moderate DIY repair solves no-heat issues fast.

Fix a dryer that won't heat or takes too long to dry clothes. This heating element assembly restores proper heat output. Moderate DIY repair.

This heating element kit generates the heat needed to dry clothes in an electric dryer. The coiled resistance wire is housed in a metal frame and heats the air as it passes through the dryer drum. Replace this kit if the dryer runs but produces no heat, takes excessively long to dry clothes, or if the element coil is visibly broken.

Dryer not heating or taking too long to dry? This heating element assembly generates hot air for proper drying. Moderate DIY repair restores heat.

Dryer not heating or taking too long to dry? This heating element is the most common fix. Moderate difficulty repair that typically takes 30-45 minutes.

The oven control and overlay assembly are installed directly in the front of the main console of the oven. They contain the control interface of the appliance. When the overlay assembly and control interface malfunction, normally, the backlight goes out behind the console. The user is unable to see any controls or function information. This malfunction can be caused by electrical short or external damage. It's possible a fuse could be the problem, and a voltage tester can give you a clear indication of where the problem lies. Begin the installation by unplugging the oven first. Using a screwdriver, unthread the screws around the perimeter of the main user interface. This will allow the casing around the console to come off. On the rear of the oven, remove the screws holding the back panel in place until the control board can be seen. Unscrew the control board assembly from the control overlay assembly. Repeat these steps in reverse with the new part.This GE oven control and overlay assembly is a genuine OEM product sourced directly from the manufacturer. The listed product is sold individually. This part is compatible with GE, Kenmore, HotPoint, RCA, and Kenmore.

Dryer not heating or taking too long to dry clothes? This PTC heating element restores proper heat output. Moderately easy DIY repair for most models.

Dryer not heating or taking too long to dry clothes? This heating element heats air as it passes through the blower. Moderately difficult repair.

Dryer not heating or taking too long to dry? This heating element generates the heat needed to dry clothes efficiently. Moderate DIY repair.

Dryer not heating or taking too long to dry? This heating element generates the heat needed to dry clothes. Moderate difficulty repair, typically 30-45 minutes.