Electrolux Cap Or Cover

Replacement cover for refrigerator damper control assembly. Snaps into place over the control box. Replace if cracked, broken, or missing tabs prevent secure fit.

This plastic gate cap cover installs inside your refrigerator compartment. Replace if the original is cracked, broken, or missing to restore appearance.

Protective cover for EPS foam insulation in your refrigerator. Replace if cracked, broken, or missing to maintain proper insulation and appearance.

This bypass is a small electrical connector used to complete or reroute a circuit inside the appliance, restoring continuity so the unit can be tested or operated while diagnosing a faulty component. What it does:

• Provides a safe path to complete an electrical circuit when a component or sensor is removed for testing
• Helps verify whether a control or subsystem is causing an interruption in power or signal
• Can be used temporarily to isolate faults and confirm repairs
• Resolve symptoms like intermittent operation or no-response from a circuit while troubleshooting

• Disconnect all power to the appliance before installing to avoid shock or damage
• Intended for diagnostic or temporary use; replace failed components with correct OEM parts for permanent repair
• Follow the appliance wiring diagram and manufacturer's instructions
• Ensure secure, insulated connections to prevent short circuits

Replaces your refrigerator's ice maker cover if cracked, broken, or missing. This protective cap installs on the ice maker assembly in your freezer.

This is the rear control panel (backsheet) that mounts behind the main console of the washing machine. It provides structural support and houses or covers the control board and wiring connections. Replace this panel if it is cracked, warped, or damaged, which can leave internal electrical components exposed.

Replacement sensor cover cap for your refrigerator. Protects internal sensors from dust and damage. Order a new cover if yours is cracked or missing.

This cover-damper is the plastic airflow housing that protects and directs cold-air damper components so the refrigerator can regulate fresh-food compartment temperature more reliably. What it does

• Houses and protects the damper assembly that controls airflow from the freezer to the fresh-food section
• Directs and seals airflow to help maintain even temperatures in the refrigerator compartment
• Failsafe symptom language: replace if the damper cover is cracked, broken, or missing, or if you notice uneven temperatures, warm spots, or reduced cold air delivery
• Helps prevent air leaks that can cause frost buildup or cause the refrigerator to run longer than normal

• One cover-damper housing

• Disconnect power to the appliance before beginning any repair
• Remove shelves/panels as needed to access the damper; handle plastic tabs gently to avoid breakage
• Align the cover with the damper assembly and snap or fasten into place without forcing
• If the damper or related parts are damaged, inspect and replace those components as needed for proper operation

Upper door hinge cover for side-by-side refrigerators. Conceals top hinge hardware for a clean finish. Replace if cracked, broken, or missing.

Covers and protects the upper door hinge area on your refrigerator. Replace this plastic cap if cracked, broken, or missing to restore a clean look.

Interior cover that shields the evaporator coil assembly and directs airflow. Replace if cracked, broken, or missing to protect internal components.