Electrolux Housing Or Cover

Protective housing cover for the refrigerator temperature sensor. Mounts on the fresh food compartment wall. Replace if cracked, broken, or missing.

Junction box housing for wall ovens. Installs at the electrical connection point. Replace if cracked, damaged, or missing to safely enclose wiring.

Replacement housing cover for range hoods. Installs as the exterior shell or casing. Needed when original is cracked, dented, discolored, or damaged.

This liner sump is the molded drain pan that collects and channels defrost and condensation water inside the freezer/refrigerator cabinet, helping prevent leaks and directing moisture to the drain system. What it does:

• Collects defrost and condensation water from the evaporator area
• Channels water to the cabinet drain to avoid pooling and potential leaks
• Helps keep the freezer/refrigerator interior dry and reduces ice build-up around the evaporator
• Compatible with OEM mounting points and drainage pathways when correctly installed

• One liner sump

• Disconnect power to the appliance before beginning service
• Access may require removing interior panels or the evaporator cover; follow factory service instructions
• Handle carefully to avoid damage to the molded drain passages; ensure proper seating and seal when reinstalling
• After installation, restore power and run a short defrost or water test to ensure proper drainage

Replace a cracked or broken control housing box in your refrigerator. This protective cover installs over electronic controls and wiring components.

Replace your gas range's burner control knob housing cover if cracked, broken, or missing. Installs on the control panel to protect internal components.