Electrolux Screws, Nuts, Washers

Microwave mounting screw used to secure internal components or attach the unit to cabinets. Replace if screw is stripped, missing, or broken.

Replace your microwave's mounting nut if the original is stripped, missing, or damaged. Secures components during installation and ensures stability.

A replacement union hex nut that secures a refrigerator water line or tubing to a mating valve or fitting, restoring a tight, leak-free connection. Simple, serviceable fastener used on water and refrigeration line unions. What it does

• Secures tubing or line to a mating union fitting or valve to maintain a sealed connection
• Stops leaks at the union when worn or damaged nuts allow seepage
• Helps restore proper water flow to dispenser or ice maker when connection is the cause
• Works with compatible refrigerator water and refrigeration line unions

• One union hex nut

• Shut off the refrigerator water supply before starting work
• Tip: loosen slowly and re-tighten by hand then wrench to avoid overtightening and damaging tubing
• If replacing a corroded nut, inspect the ferrule/sleeve and mating fitting and replace if damaged

Replacement mounting nut for your dishwasher. Secures internal components and panels. Order a new nut if yours is stripped, cross-threaded, or missing.

This is a single replacement screw used to secure panels, trim, or components on compatible Frigidaire appliances. It restores proper fastening to stop loose parts and reduce vibration or rattling. What it does:

• Secures panels, brackets, or trim pieces to the appliance chassis
• Helps stop rattling, vibration, and misaligned panels caused by missing or loose hardware
• Restores correct fit and alignment for covers and mounting points
• Simple replacement when original screw is lost, stripped, or damaged

• One replacement screw as shown

• Unplug the appliance or shut off power before servicing
• Use the correct screwdriver or driver bit to avoid stripping the head
• Replace only with the same size and type of screw for proper fit
• If threads are damaged, inspect the mating part and repair or replace as needed

Replacement mounting screw for dishwasher assembly. Secures internal components and panels. Order if original hardware is stripped, missing, or damaged.

Mounting screw for gas ranges. Secures internal components and panels. Replace if screw is stripped, missing, or damaged during appliance service.

Mounting screw for range installations. Secures panels, brackets, or components. Replace if stripped, missing, or corroded during repairs or reassembly.

Replace your microwave door gasket to restore a proper seal and prevent heat loss. Fixes worn or damaged seals for consistent heating. Verify fit.

A single replacement mounting screw used to secure panels, brackets and trim on compatible appliances. Restores proper fit and stops rattling or loose components so panels stay aligned and stable. What it does:

• Fastens panels, brackets or trim pieces to appliance chassis
• Helps eliminate rattling, vibration noise, and loose or sagging panels
• Restores secure attachment after stripped or missing fasteners
• Works with the corresponding threaded hole or nut to hold parts in place

• Use the correct screwdriver or bit to avoid stripping the head
• Tighten until snug; do not overtighten to prevent thread or part damage
• Disconnect power to the appliance before servicing if panels expose electrical components
• Ensure that hardware is properly seated before tightening

Mounting screw for microwave installation. Secures microwave to cabinet or wall bracket. Replace if missing, stripped, or damaged during installation.

Genuine mounting bolt for dishwashers. Secures internal brackets, panels, and assemblies to the chassis. Replace if missing, stripped, or damaged.