Frigidaire Gasket & Seal

Replace your refrigerator door gasket seal to restore airtight closure and improve energy efficiency. Fix warm temps and condensation. Verify fit by model.

Dishwasher door gasket creates a watertight seal to prevent leaks during wash cycles. Replace if you notice water leaking or seal damage. Verify fit with your model number before ordering.

O-ring seal for dishwashers prevents leaks in spray arms, pumps, and valves. Replace when worn, cracked, or leaking. Verify fit with your model number.

This is a metal plate that mounts behind the control panel of a range, acting as a protective shield for wiring and electronic components. It helps block heat from the oven cavity and prevents grease or debris from reaching sensitive parts. Replace this plate if it is warped, corroded, or damaged, which could expose control components to excessive heat or contamination.

Foam seal for refrigerator air deflector. Replace if torn, compressed, or causing temperature issues. Ensures proper airflow between compartments.

Seals the lint housing to prevent air leaks and maintain drying efficiency. Replace if worn, cracked, or causing lint buildup. Confirm fit with your model.

This O-ring is a small rubber seal that restores a watertight connection at a plumbing or valve joint, helping stop drips and leaks and keep your appliance operating normally. What it does:

• Provides a flexible, compressible seal between two mating parts to prevent water leaks
• Commonly used on valve fittings, hose connections, and dispenser plumbing
• Symptoms a failing O-ring can cause: visible dripping, pooled water, or intermittent water flow
• Small, low-cost part that often resolves minor leaks when the correct size is used

• Turn off water supply (and power if applicable) before replacing the O-ring
• Remove the old O-ring and inspect mating surfaces for damage or debris; clean before installing the new ring
• Do not reuse a deformed or torn O-ring; install the correct size and seat it evenly
• After installation, restore water and check the connection for leaks; tighten fittings only as needed to avoid crushing the O-ring

This support is a replacement mounting bracket that helps secure internal components and keeps assemblies aligned for reliable operation. It restores proper fit and reduces noise caused by loose or shifted parts. What it does:

• Secures and stabilizes appliance panels or assemblies to prevent movement and rattling
• Restores proper alignment of connected components to improve operation
• Helps stop vibrations that can cause noise or wear on adjacent parts
• Common symptom fix: loose, cracked, or missing support causing rattling, misalignment, or unstable panels

• One support mounting bracket as shown

• Disconnect power to the appliance before starting any repair
• Use appropriate hand tools and keep fasteners organized during disassembly
• Inspect neighboring clips, screws, and mounting points; replace if damaged

Replace your refrigerator's fresh food door gasket to restore proper sealing and energy efficiency. Prevents warm air leaks and frost buildup. Verify fit by model number before ordering.

This is a white rubber door gasket that seals the freezer compartment door to prevent warm air from entering. It attaches magnetically along the inner edge of the door frame. Replace this gasket if you notice frost buildup inside the freezer, the door does not stay closed on its own, or the seal appears cracked, torn, or deformed.