Frigidaire Gasket & Seal

Replace your range oven door gasket to restore heat retention and cooking efficiency. Worn gaskets cause heat loss and uneven temperatures. Verify fit with your model number.

This glider is a replacement drawer support that helps guide and stabilize a sliding refrigerator or freezer drawer for smooth opening and closing. It restores proper alignment and prevents the drawer from sticking or falling out of its track. What it does:

• Guides the drawer along its track to ensure smooth, even movement
• Maintains drawer alignment to prevent binding or tipping
• Replaces worn or broken gliders that cause noisy or jerky operation
• Helps the drawer seat properly so it opens and closes without snagging

• One glider (single drawer support)

• Inspect the track and mating hardware for damage or debris before installing
• Typically snaps or slides into place—no special tools required for most installations
• Replace matching left/right pieces as needed for balanced operation
• For appliance safety, work with the drawer empty and follow OEM service precautions

O-ring seal for washer dryer combos. Replace when leaking or worn to prevent water damage. Verify fit with your model number before ordering.

This refrigerator door gasket creates an airtight seal around the door to help maintain proper temperature and energy efficiency. Replacing a damaged gasket restores sealing performance and helps prevent cold air loss. What it does

• Seals the refrigerator compartment to keep cold air in and warm air out
• Helps maintain consistent cooling and reduces frosting/condensation
• Prevents food spoilage related to poor door sealing
• Reduces excessive run time caused by air leaks

• One door gasket as shown

• Clean and dry the door frame before installing to ensure a proper seal
• Soften the gasket in warm water or use a hair dryer on low to ease positioning if needed
• Start installation at the corners, working around the door to seat the gasket evenly

This replacement door gasket creates a tight seal around the refrigerator door to help keep cold air in and warm air out, protecting food and improving cooling consistency. What it does:

• Seals the door to reduce air leaks and prevent temperature fluctuations
• Helps stop frost and moisture buildup inside the fresh-food compartment
• Restores proper door closing and alignment when worn or torn
• Can reduce compressor run-time caused by air infiltration

• Disconnect power to the appliance before starting any work.
• Remove the old gasket and clean the channel before installing the new gasket.
• Start installing at one corner and work around the door, ensuring the gasket seats fully in the channel.
• If needed, gently warm the gasket to increase flexibility for an easier fit (use low heat and caution).