This clamp secures small hoses or tubing and nearby wiring inside the appliance to keep lines held in place and reduce rubbing, leaks, or vibration noise. It's a direct-fit replacement designed to restore proper hose routing and stability. What it does:
- Holds water, drain or vent tubing securely to prevent sagging and rubbing that can cause leaks or wear
- Keeps hoses and wires aligned to reduce vibration and rattling during operation
- Helps maintain proper connections at fittings so seals stay seated and drip risk is minimized
- Simple mechanical clip action — no special tools or adhesives required
Install notes:
- Disconnect power and shut off the water supply before starting any repair
- Remove the old clamp and install this clamp in the same orientation; tubing sits fully in the fitting
- Use standard pliers (or the OEM-recommended tool) to compress/seat the clamp; avoid twisting or pinching the tubing
- Inspect surrounding tubing and fittings for wear; replace damaged hoses or seals if found
Do-It-Yourself Stories from Customers like You
Had a cracked plastic ice maker inlet water tube that flooded part of kitchen floor Terry C. • Durham , NC • February 16, 2019
Replaced original (18 yrs.) 1/4" plastic tubing, clamp and grommet (AppliancePartsPros/GE parts) from outlet of ice maker water control valve to ice maker inlet. Also replaced water supply line to inlet of water control valve with new, GE braided, PEX 1/4" supply line with pre-attached female compression fittings on both ends. Repair job with AppliancePartsPros parts from outlet of water control valve went perfectly well, was simple, and had no leaks when tested. Parts were easy to install,...
Read more