General Electric Refrigerator Parts

Refrigerator not cooling or running hot? A failed condenser fan motor prevents heat removal from the condenser coils. DIY repair in under 30 minutes.

Secures the evaporator fan assembly behind the rear freezer panel. Replace if cracked, rusted, or missing to restore proper fan mounting and clearance.

Bottom hinge that supports the refrigerator door weight and serves as the pivot point. Replace if worn, cracked, or causing door misalignment and sagging.

This dispenser cover assembly replaces a cracked or damaged dispenser housing cover to restore a clean appearance and help the dispenser direct ice and water properly. Molded plastic protects internal components and maintains dispenser alignment. What it does:

• Covers and protects the dispenser opening and internal components from dirt, moisture, and impact.
• Helps guide ice and water to reduce jams, misfeeds, and drips at the dispenser opening.
• Restores appearance when the original cover is cracked, split, or cosmetically damaged.
• Seats into the dispenser housing using factory clips and mounts to maintain proper alignment.

• Disconnect power and shut off the water supply before servicing to prevent shock and leaks.
• Remove dispenser trim or inner door panel to access the cover; support the door/trim while working.
• Handle plastic clips and tabs carefully—damaged clips may require replacement.
• After installation, restore power/water and test the dispenser for proper function and leaks.

Creates an airtight seal between door and cabinet. Replace if worn, torn, or causing air leaks and frost buildup. Verify fit with your model number.

Plastic water tube that routes water between refrigerator components like the inlet valve, dispenser, and ice maker. Replace if cracked, brittle, or leaking.

Leveling leg threads into the refrigerator base to support and stabilize the cabinet. Replace if cracked, broken, or worn to keep your unit level.

Glass insert for refrigerator pan cover, forming the flat shelf above crisper drawers. Replace cracked, broken, or missing glass to restore a stable surface.

This crisper cover sits above the vegetable drawers, supporting the shelf surface and guiding the bins. Replace a cracked or sagging cover to restore support.

Fixes ice buildup in freezer and warm fresh food compartment. This bimetal defrost thermostat controls heater cycles to prevent frost accumulation.

Outer drawer slide rail for refrigerator pantry drawers. Guides drawer movement for smooth opening and closing. Replace if cracked, bent, or worn out.

Secures the condenser fan motor in position. Replace this bracket if cracked, bent, or causing excessive vibration to restore stable mounting.

Color: white. Measures about 15 inches wide by 4-1/2 inches high by 7-1/2 inches deep.

Fixes no water to ice maker, slow water flow, or leaking connections. Includes dual valves and bracket. Simple 10-minute repair with basic tools.

The R134 Drier is an OEM part for GE refrigerators. This component plays a critical role in the refrigeration system by removing moisture and contaminants from the refrigerant, ensuring efficient cooling and preventing damage to other parts of the system. It helps maintain the purity and effectiveness of the refrigerant as it cycles through the system.

You should replace the R134 drier if it becomes clogged or damaged. Common causes of a bad drier include wear and tear over time, exposure to moisture, or contamination from other failing components in the refrigeration system.

Symptoms of a bad R134 drier include:

• Reduced cooling efficiency
• Frost buildup on the evaporator coils
• Unusual noises from the refrigeration system
• Increased energy consumption
• Refrigerator not maintaining the set temperature

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

Replacement mounting screw for refrigerator panels, brackets, and hardware. Restores secure fit when original is missing, stripped, or corroded.