Kenmore / Sears Parts

You have to take the knob off the broken part, then buy the new switch element and fix it. To do this you turn the power off, take out 6 fasteners to release the front panel of the stove and replace the switch element. Then put it all back together. Very simple. But if the knob was designed better it would not have broken in the first place. It looks nice, but this is the third time I have had to fix one. Read more

Replaced two switches that controlled two front burners. One controlled three different burner sizes options in one burner. The other was the speed burner, basically three different burner options in one burner. Read more

• Will not stop filling with water
• Will not fill with water

Reviewed troubleshooting tips and identified problem as "water level switch". Watched repair video, which was very helpful. Ordered part on a Sunday, which arrived the following Tuesday. Repair was easy the fix was successful. Read more

• Light not working

Ordered switch....turned out it was the socket that was bad...ordered socket.....quick install....light works Read more

Swapped old with new. dead easy and fast delivery of part helped: good service, thank you . Read more

I replaced the cycle switch, fixing the lack of heat. The timer switch replacement fixed the auto cool down. I watched a cycle switch replacement on Youtube, demonstrating removal of the top console, which answered the only question I had about the repair. The timer switch was a hundred bucks. The only thing to be said about that is that it was a lot cheaper than a repairman or replacing the dryer. Read more

• Won't start

I was searching the web for solutions and came across two folks who had similar trouble code. One fixed his by removing the pump strainer from the pump to find coins blocking water flow, thus the analog water pressure sensor provided a failure response. My issue was solved by following the other hints I got. I ordered a new sensor (switch). It was expensive for what it is, but the washer will not run correctly without it! The part arrived in a very timely manner, and it was the right part.... Read more

I replaced the control board and the microswitch. Read more

• Won't start

Kitchenaid should have supplied this kit to it's customers. The kit is of a much better design than the flimsy original. Fairly easy to install. Read more

Ordered light switch and it arrived the following day with standard shipping! That was FAST!! Removed old swich, installed new, only 2 wire switch, very easy. I was very impressed with the 1 day delivery Read more

• Light not working
• Not dispensing water
• Ice maker not making ice

Ordered 2 light switches and replaced them. Read more

Replaced switch Read more

This was a very simple repair. It was done in about an hour. It involves disconnecting the dishwasher, emptying the water from the inside, taking it out and flipping it over, and replacing the diverter motor. This repair is done on the underside of the dishwasher, nothing to disconnect inside (just remember to remove the baskets). It would be wise to order the motor seal and micro switch that goes with it as they are all cheap parts and easy to swap out during the procedure. Be sure to take... Read more

I replaced the assembly behind the water level knob. I watched the video on appliancepartspros.com before starting, and then watched it again in short portions while going thru the repair process. Read more

• Will not stop filling with water
• Will not fill with water

At first, I thought, maybe I should just get a new washing machine. After all, it is almost 20 years old! I couldn't bring myself to do that and said to myself, let me see if I can figure out what parts I need and see if I can find a video that tells me how to do it and see how hard it is. I’ve never attempted appliance repair before. After figuring out what the most likely parts were, I ordered the water level switch and agitator cam repair kit - I figured for $10 more, I might as well... Read more