Kitchenaid Bracket & Flange

This support bracket secures and stabilizes appliance panels and internal assemblies where a small mounting brace is required. It restores proper alignment and helps prevent vibration or sagging for a firmer fit and quieter operation. What it does

• Anchors and supports panels, trim, or internal components to the cabinet or frame
• Keeps assemblies aligned to prevent rubbing, gaps, or misalignment
• Reduces rattling and vibration caused by loose or missing bracketry
• Restores proper fit when original bracket is bent, broken, or missing

• Disconnect power to the appliance before beginning any repair
• Inspect mounting location and replace any stripped fasteners or damaged hardware
• Use the correct screws and hand tools to avoid stripping or overtightening

Mounting bracket that secures the bottom trim vent on your wall oven. Replace if the bracket is bent, broken, or missing to properly secure trim pieces.

Secures the water tank assembly to your refrigerator cabinet. Replace this bracket if it's cracked, broken, or missing to keep the tank stable.

Mounting bracket for dryer shunt assembly. Secures electrical shunt component to cabinet frame. Replace if cracked, bent, or missing hardware slots.

Support bracket for wall ovens. Secures internal components in place. Replace if bracket is bent, cracked, or missing to restore proper assembly.

Mounting bracket for gas ranges. Secures components in place. Replace if bent, broken, or missing. Direct fit for compatible range models.

Mounting bracket secures internal refrigerator components for stable alignment. Replace if cracked, bent, or broken to restore proper support and positioning.

Mounting bracket for bottom-mount refrigerators. Secures internal components in place. Replace if bracket is cracked, broken, or missing hardware.

Replacement mounting bracket for built-in microwaves. Secures panels and components for proper alignment. Order if your original bracket is cracked or broken.

Secures the temperature sensor or thermostat to the dishwasher cabinet. Replace if the original bracket is cracked, broken, or missing hardware.

Anchor tip bracket for gas ranges. Secures and stabilizes internal components. Replace if bent, broken, or missing to restore proper fitment.

Rear support base bracket for refrigerators. Secures base components at the back of the unit. Replace if cracked, broken, or missing for stability.

Secures the icemaker assembly inside your refrigerator freezer compartment. Replace this bracket if it's cracked, broken, or missing to restore support.