Kitchenaid Support Parts

Receiver that attaches to the upper wash rack and connects to the water delivery tube. Replace if cracked, deteriorated, or missing seal component.

Left hand side. For the right hand side order 814373.

Mounting rail for wall ovens. Installs on the cabinet frame to secure the oven unit. Replace if bent, damaged, or missing during installation or removal.

Mounting rail for wall ovens. Secures oven components to cabinet or frame. Replace if bent, rusted, or damaged during installation or removal.

A replacement support control bracket that secures the appliance control/console to the cabinet, restoring stable button alignment and preventing the control panel from sagging or shifting during use. Durable stamped metal design for reliable mounting. What it does:

• Secures the control console to the appliance cabinet so the control assembly stays properly positioned
• Prevents the control panel or console from sagging, rocking, or coming loose
• Helps maintain proper alignment of switches, knobs, and electronic controls
• Resolves intermittent button contact or usability issues caused by a loose console

• Disconnect power before beginning any service to avoid shock or injury
• Basic hand tools (screwdriver, nut driver) are typically required; keep original fasteners if present
• Align bracket with factory mounting points and tighten hardware securely but avoid overtightening

Telescopic frame support plate for range hoods. Mounts inside the unit to provide structural support. Replace if cracked, bent, or damaged during install.

Replacement mounting plate for microwaves and over-the-range units. Restores proper fit and alignment. Replace when cracked, warped, or damaged.

Support frame for refrigerators. Mounts internally to provide structural support. Replace if cracked, broken, or damaged to restore proper alignment.

This is a metal mounting rail used to secure the compressor unit to the base of the refrigerator. It provides stable support and helps reduce vibration during compressor operation. Replace this rail if it is bent, cracked, or corroded, or if you notice excessive vibration or unusual noise coming from the bottom of the refrigerator.

This bearing plate supports the dryer drum shaft and secures the bearing assembly so the drum spins smoothly and stays aligned. Replacing a worn plate restores stable drum rotation and helps reduce noise and rubbing. What it does:

• Provides a mounting surface and alignment for the drum bearing and shaft
• Keeps the drum centered to prevent wobbling, scraping, and uneven wear
• Reduces loud bearing or metal-on-metal noises caused by a damaged plate
• Helps maintain smooth drum rotation and proper belt alignment

• Turn power and gas off to the appliance before starting work
• Inspect surrounding components (bearing, shaft, seals, mounting screws) and replace if damaged
• Use correct fasteners and torque to secure the plate; improper mounting can cause noise or premature wear

Molded grease channel drip tray for range hoods and downdraft ventilation systems. Replaces cracked, worn, or missing trays that collect cooking grease.

Grease channel support plate for downdraft ventilation systems. Mounts inside the unit to secure the grease filter channel. Replace if cracked or broken.

Support plate for range hood installation. Provides structural mounting stability. Replace if cracked, bent, or missing during installation or repair.

Replacement mounting plate for refrigerators. Provides a stable surface to secure components. Needed when original plate is cracked, broken, or missing.