This rivet assembly is a direct-replacement fastening piece used to secure appliance panels and components, restoring a stable, rattle-free fit and preventing movement caused by worn or broken rivets. What it does:
- Secures panels, brackets, or component mounts to restore proper alignment and support
- Stops rattling, vibration, or loose hardware caused by damaged or missing rivets
- Provides a durable mechanical fastener where original rivets have sheared or loosened
- Helps maintain safe operation by keeping parts properly retained
What's included: One rivet assembly Install notes:
- Disconnect power (and gas/water if applicable) before attempting any repairs
- Removal may require drilling out the old rivet; installation typically needs a rivet gun or equivalent tool
- Keep hardware orientation the same as the original; replace any damaged surrounding parts
Do-It-Yourself Stories from Customers like You
Ge microwave: sparking melted hole in stirrer fan cover and it would not run without sparking Henry H. • Swanton , OH • September 10, 2016
I replaced the stirrer fan cover and fan, which had some carbon and slight burn marks on it. It was difficult to remove the fan cover as it did not rotate. I had to pry it off with a flat blade screwdriver, breaking the plastic tabs on the cover (which was being discarded anyway). I then cleaned any visible carbon deposits and replaced the cover and fan, using the old stirrer fan holder as it appeared OK. However, I was unable to rotate the cover into the locked position so I could not insert...
Read more