Your privacy choices: We and our partners use cookies for analytics and ads. Decline all turns them off.
Privacy Policy · Do Not Sell or Share My Personal Information
Need Help?
Call
Burner not heating or 'Hot Surface' light stays on? This electric cooktop surface element is likely the fix. DIY-friendly, most installs take 15 minutes.
Turned off power supply. Removed two screws (near the oven door) holding the ceramic top. Slid the top forward, disengaged the two power supply cables, and removed one ground wire. Removed range top, and put on a flat surface. Unclamped two power supply wires, one ground wire and one thermocouple wire from the element. Unscrewed the bracket from the element, and remove the element from the range top. Remove the two clamps from the old element, and put them on the new element at the same... Read more
Oven not browning or broiling? A faulty broil element won't heat up. Easy DIY fix—disconnect power, remove screws, swap wires. Video guide included.
Installed new heater element. Read more
Burner not heating or glowing red at all settings? This surface heating element restores stovetop heat. Easy DIY fix with basic tools in 10 minutes.
The heating element contact ears and the terminal block contacts were burnt on the existing burner. I ordered the new terminal block kit and surface heating element from Appliance Parts Pros. Delivery was exceptionally fast (I just used regular shipping). The new terminal block kit came with very long wires, so I cut them and installed new terminal ends, rather than zip-tie the long wires together. Very happy with repair. Read more
Broil element not heating or broken? This part provides intense radiant heat for broiling. Straightforward DIY replacement takes about 15-20 minutes.
I had the choice of spending $2K on another double oven stove or $60 on two elements. (I felt more secure about replacing both bake and broil elements just in case the fire had damaged the bake element) It was an easy decision and quick replacement! Power was already off to the stove so I cleaned up the fire retardent mess. I even found easy instructions dismantling the oven door in order to clean the powder residue from between the glass. I then removed the rack and remaining old elements. I... Read more
Oven won't heat or bake properly? A failed bake element is often the cause. This bottom heating element replacement is straightforward—most DIYers complete it in under 30 minutes.
Watched the video here, took the leap that burner was the problem and ordered it. Also found another vid on you tube that was more specific to my Kenmore. Tip: find out how to take off the oven door. For mine it was very easy but not detailed in the APP vid. I followed instructions in APP vid but also first took off back panel of range and tested resistance of old burner to ensure that was truly the problem (as suggested by other YT vid). Also, dis/connecting the wires from the back is easier... Read more
Replace a burner that won't heat or heats unevenly. This 8-inch surface element restores proper cooking temperature. Easy DIY repair in minutes.
Personally I have experience working with electricity and knowing if I bought the part required this would be an easy fix. I got my model number and contacted Appliance Parts Pros and placed my order for the new elements, terminal blocks, and for appearance purposes 4 new Drip Pans. Excellent service and quick shipping. I ordered my parts on Sunday and received them on Tuesday. This was a simple repair that only required a screwdriver to remove the old terminal block from the range hood, wire... Read more
The 6" Surface Burner with Sensor is an OEM part for GE ranges. This part provides precise heating for cooking on your range's stovetop. The integrated sensor helps regulate the burner temperature, ensuring even and consistent cooking results. Common causes of a bad surface burner include electrical issues, wear and tear over time, or damage from excessive heat or spills. Symptoms of a bad surface burner with sensor include:
This OEM GE part is also compatible with Hotpoint, RCA, and some Kenmore models.
Put in a new 6" surface burner. Read more
Broiler not heating or glowing red? This broil element restores high-heat broiling from the top of your oven. DIY repair in 15-30 minutes with basic tools.
I have had this oven for 40+ years. It is an enamel oven, something that you can no longer buy. Because I did not wish to buy new, I decided to service it myself and searched for the parts I needed. AppliancePartsPros.com was the only site to offer all three parts, so many having been discontinued by other providers. I replaced the oven gasket, the broiler element & the lens without any difficulty. I have replaced the bake element previously as well. I am very grateful that I was able to keep... Read more
The Surface Heating Element is an OEM part for GE ranges. The element is a large 8" plug-in style burner. This element is designed to provide consistent and even heat for cooking on the stovetop. It is typically used for tasks such as boiling, simmering, and frying, ensuring that your cookware heats up efficiently.
You should replace the surface heating element if it becomes faulty. Causes of a bad surface heating element can include wear and tear from regular use, electrical faults, or physical damage. Over time, the element may degrade, affecting its ability to heat properly.
Symptoms of a bad surface heating element include:
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.
Replaced defective/worn surface unit and burnt receptacle! Read more
Broil element not heating or burned out? This top heating element restores high-heat broiling for browning and crisping. DIY-friendly, 15-30 minute repair.
Pulled stove out from wall and unplugged for safety, removed back cover to check for any wire damage because the element blew out pretty bad but wiring was ok, removed wires from broil element at the back of the stove. Went to the front of the stove opened door and removed hangers and finally the element screws on broil element. I also unwired removed the bottom element to clean the inside of the oven with soap and water because the whole inside of the oven was cover in a light white coat of... Read more
Range burner not heating? This 8 inch surface element restores full heating power. DIY-friendly installation takes 10-15 minutes with basic tools.
Ordered new parts and replaced all. Had to slightly modify the wire terminals all four surface elements so that they would fit the ceramic insulators that were shipped with each one. Read more
Broiler not heating or won't turn on? This broil element assembly restores high-heat broiling. Most DIYers complete this repair in under 30 minutes.
I ordered the replacement part; after it arrived, I turned off the power to the oven - watched the video on how to replace the part, which was fantastic as it told me to make sure when I disconnect the old element not to let the wires fall behind the oven (that would have been a big problem b/c it's a wall oven) - However, one wire still slipped back a little - so I used needle nose pliers to retrieve it. Was able to plug the new one in - screw it into place with the original screws. I made... Read more
Freezer icing up or frost building on coils? The defrost heater melts ice from evaporator coils. Moderately difficult repair, about 1 hour install time.
Fridge keept building up ice in defrost drain drain in freezer. Once the drain pan filled with ice it drips into fridge compartment. After taking things apart three times to thaw it out, decided to replace defrost components - heater and temperature switch. In addition to new parts, also added a 12 gauge copper wire hook that hangs from defrost heater into the defrost drain. After this, the defrost cycle is running as expected, but will not know if the issue is corrected until a year or so... Read more
Broil element broken or not heating? This top heating element restores high-heat broiling in electric ovens. DIY-friendly repair, typically done in under 30 minutes.
I needed to replace the oven broil element on my 15 year old GE range/oven unit. The broil element was broken in half during an oven self-cleaning cycle. Due to the age of the oven, I decided to replace both the broil and bake elements. I ordered the elements from Appliance Parts Pro. Their web site made it very easy to identify and locate the correct replacement parts. The parts arrived in 2 days. I watched the repair demo videos available for each element. Although the oven used in the demo... Read more
Oven not heating or baking unevenly? The bake element provides bottom heat for cooking. Simple DIY repair, typically takes under 20 minutes to replace.
1st. replaced thermostat probe inside wall oven - no change. Then removed range heating element and measured it with ohm meter for continuity and found it to be OPEN. Ordered replacement range heating element; measured it before install and found it to be a few ohms - installed in less than 5 minutes and tested. ALL WORKS GREAT. Both items purchased with shipping were just over $100. (I chose to keep the thermostat probe instead of returning it being the oven is just over 10 years old). Read more
This is a 3000-watt bake element that mounts in the bottom of the oven cavity. It provides the primary heat source for baking and roasting. Replace this element if the oven is not heating properly, food is undercooked, or the element shows visible damage such as cracks, blistering, or burn-through spots.
Replaced the oven heating element Read more
Opt-Out Request Honored
We use cookies to optimize website functionality, analyze the performance, and provide personalized experience to you. Use the controls below to manage your privacy preferences.
Cross-Site Advertising
When enabled, we may use cookies and similar technologies to deliver personalized advertisements based on your browsing activity across different websites. Opting out will disable third-party advertising cookies on this site.
Analytics Sharing
When enabled, we may share anonymized browsing and usage data with third-party analytics providers to help us understand how visitors use our site. Opting out will prevent this data from being shared with third parties.