Need Help?
Call or text
Replacement door bin trivet for refrigerator inner door storage. Holds condiments, jars, and bottles. Replace if cracked, broken, or missing.
Wonderful, replacement part fit perfectly. Read more
Creates an airtight seal to keep cold air in and moisture out. Replace if torn, worn, or causing the door to pop open. Confirm fit with your model.
Previous tenants damaged the refrigerator by ripping the gaskets out and breaking the glass shelf over the veggie-drawers. I tend to replace things instead of fixing them, but AppliancePartsPros made it so easy to find parts. The gaskets and glass were specific to my make and model. Easy to install and worked perfectly. Definitely a win! I plan to do the same type of repair work to the dishwasher next. Read more
Fix a noisy or non-cooling refrigerator with this condenser fan motor. Solves overheating compressor issues. DIY-friendly repair with video guide.
I bought the listed condenser fan motor for my Maytag refrigerator. Access to the condenser fan is by removing sheet metal screws of bottom panel with 1/4 in. nut driver. Condenser fan is on left side of rear access area. Remove electrical connector by pressing-in connector release tab with thumb fingernail and pulling on connector. Remove three mounting screws with 5/16 nut driver. Work fan out to the right past the compressor. I used a pair of pliers, as a lever, behind the plastic fan blades... Read more
Replace your refrigerator's interior light bulb when it burns out to restore visibility. Easy screw-in installation. Verify fit with your model number.
Put a new one in an easy fix but a hard bulb to fine Read more
Protective washer that sits between the door hinge and frame. Replaces worn or missing washers that cause door sagging, dragging, or poor seal contact.
My 10 year old frig door was hanging down to the point it wasnt fully closing and sealing unless you picked up on it. I ordered a lower hinge bracket, upper and lower bearing, and spacer. My bracket was bent down a little due to my kids hanging on the door when looking at the bottom shelf and i discovered my bracket was held on by only two bolts when there was supposed to be three. I ordered a bolt too. I was able to remove the bottom hinge, remove door to replace upper and lower bearing and... Read more
Fix no water or ice, leaking valve, or slow water flow from your dispenser. This refrigerator water inlet valve is a straightforward DIY repair.
First I replaced the filter thinking it was the problem, but that was not the case. Next was replace water supply valve at the back of the refrigerator. It was very easy. The only thing that was in question was how to get the refrigerator side line off of the existing valve. There is a plastic slide clip that you remove and pull the line out and press the line back into the port it came out of. It was a very simple project and took about 20 minutes. Read more
The Refrigerator Display Assembly is an OEM replacement part for GE refrigerators. It is the user interface component that displays important information, such as temperature settings, operational modes, and any error codes or notifications. NOTE: Control board is NOT included. Must be ordered separately.
Symptoms of a faulty refrigerator display assembly include:
Causes of a bad display assembly can include electrical malfunctions, physical damage from impact or moisture exposure, or simply normal wear and tear over time.
This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore refrigerator models.
Replaced faceplate of refrigerator. Read more
Ice maker stopped making ice or freezing into a solid block? This ice maker assembly restores function in 15-20 minutes with just a screwdriver.
Purchased both the ice maker assembly and the valve assembly to replace the parts as needed. replaced the ice maker assembly first, and this fixed my problem. Took about 10 minutes, mainly because I didn't watch the YouTube video first. Had I watched that, it would have probably taken even less time. One Philips head screw driver is all you need. Read more
Seals freezer door to prevent warm air entry and maintain optimal temperature. Replace if worn, cracked, or causing frost buildup. Confirm fit by model.
Purchased replacement door gasket (seal). Pulled old gasket from its groove around door. Easily pressed the replacement gasket into the empty groove. Repair complete. Read more
Refrigerator not cooling or making loud noise? A failing condenser fan motor prevents proper heat exchange. Typical DIY repair takes 30 minutes or less.
Replaced compressor fan. the video on the website showed step by step. very easy and it fixed the problem. Read more
The Crisper Pan is an OEM part for Frigidaire refrigerators. This part stores fruits and vegetables at optimal humidity levels, helping to keep them fresh for longer periods. Causes of a bad crisper pan can include wear and tear from frequent use, accidental impacts, or exposure to heavy weights that cause it to crack or break. Symptoms of a bad crisper pan include:
This OEM Frigidaire part is also compatible with Electrolux, Gibson, Kelvinator and some Kenmore models.
Bought a new one! Very fast and helpful service. Read more
Refrigerator freezing food? A faulty damper assembly causes constant cold air flow to the fresh food section. DIY-friendly repair, under 1 hour.
I went on line and read your advice page. Based on that, I removed the damper assembly (six screws counting the miserable light fixture) and found the damper door broken as predicted. I went back to your page and ordered the new part. Nice breakdown to get number. After that, I disassembled the damper assembly, found that the ABS plastic damper had broken from the actuator probably as a result of fatigue from cycling back and forth for twelve years. I used super glue to re-attach the damper... Read more
Creates an airtight seal around your freezer door to prevent warm air entry and cold air loss. Replace if torn, cracked, or not sealing properly. Verify fit by model number.
Ordered the new gasket from you - installed it and now my freezer is sealed i called to order the correct replacement and they were the very best at helping me !!!!! Read more
Ice maker not dumping ice or auger motor making grinding noise? This assembly produces and dispenses ice. DIY repair in under 20 minutes with video guide.
Very easy. Video on the AppliancePartsPros website made it a no brainer. Very helpful. Read more
Secures your refrigerator's water filter in place for proper filtration. Replace if cracked, chipped, or filter won't stay locked. Confirm fit by model number.
Used screwdriver to push in plastic tabs holding old unit to the top of the refrigerator box Read more
Seals the fresh food door to maintain temperature and prevent air leaks. Replace if you notice condensation, frost buildup, or warm air entering. Confirm fit with your model number.
I checked the freezer and found the door gasket was damaged. When the parts arrived, I checked them for a good fit and the attachment method. Due to past experience of replacing door gaskets, I was expecting a lot of screws that would have to be removed and replaced. To my surprise, the gaskets pressed in place without tools and had a good and secure fit. The instructions the came with the gaskets suggested the hot water be used as needed to remove any kinks that might cause a poor fit. I... Read more