Endcap Parts

Plastic endcap that covers and protects the side edge of your range control panel. Replace if cracked, broken, missing, or discolored to restore appearance.

This right-side end cap is a replacement trim piece that secures and finishes the outer edge of the appliance door/frame, restoring appearance and helping keep the door components aligned for smooth operation. What it does:

• Covers and protects the outer edge of the door/frame and internal components from dirt and damage
• Holds adjacent trim and seals in proper position to reduce gaps and rubbing
• Restores factory appearance where a cracked or missing end cap left an exposed edge
• Helps prevent minor snagging when opening or closing the door

• Disconnect power to the appliance before starting any repair
• Removal/installation typically requires light prying or removing a few trim screws; use non-marring tools to avoid damage
• Align tabs or slots and press/secure the cap until it snaps into place; verify even fit along the edge
• If sealing or alignment issues persist after installation, check adjacent trim and fasteners for wear or damage

Left endcap for gas ranges. Covers and finishes the exposed end of your cooktop or control panel. Replace if cracked, broken, or missing.

Black plastic endcap that covers the edge of your range control panel. Replaces cracked, broken, or missing endcaps. Includes left and right pieces.

This right-side end cap replaces a worn or broken trim piece to restore a clean finish and secure fit on the appliance. It helps maintain proper alignment of the adjacent trim or shelving and improves appearance. What it does:

• Covers and protects the outer end of a trim piece or shelf; keeps edges finished and snag-free
• Secures the trim/shelf edge to prevent movement or gaps
• Common replacement when the original is cracked, chipped, warped, or missing
• Helps prevent food snags and improves overall cabinet/compartment appearance

• Typically snaps or slides into place; some models may use a single fastener — inspect the mounting area before installation
• No electrical disconnect usually required for trim parts, but remove nearby items and work carefully to avoid damage
• Wear gloves to avoid cuts from sharp edges and to protect the finish
• If the cap doesn't seat easily, check for broken retention tabs before forcing