Buzzer Or Chime

This lid actuator engages the washer's lid switch or lock when the lid closes, signaling the control that it's safe to run. Replacing a worn or broken actuator restores reliable lid detection for wash and spin cycles.

• Engages the lid switch/lock when the lid is closed
• Signals the control to allow the washer to start and spin
• A damaged or missing actuator can lead to "lid open" errors
• Common symptoms include won't start, won't spin, or lid lock light flashing

• Disconnect power before servicing
• Access the lid switch/lock area; remove the failed actuator
• Install the new actuator, aligning it to the original mounting points; reuse existing hardware
• Close up and test lid detection before running a full cycle

This water inlet valve regulates the flow of water into the appliance. When the control calls for water it opens; when closed it stops flow. Replacing a faulty valve helps restore proper filling and prevent unwanted leaks. What it does:

• Opens and closes to control the water supply to the system
• Helps maintain correct water flow during fill operations
• Common symptoms of a failing valve: no water enters, slow or intermittent fill, water continues to flow when off, leaks at the valve or connections, or a humming/buzzing sound with little/no water

• 1 water inlet valve

• Disconnect power and turn off the water supply before servicing
• Place a towel or container to catch residual water; relieve line pressure
• Reconnect tubing and fittings securely; do not overtighten compression nuts
• Restore water and power, then check all joints for leaks and run a test fill to purge air

Fixed buzzer that replaces the appliance's audible tone generator in the control panel, restoring beeps and alerts for cycle completion and fault signals. Simple swap that returns audible notifications used during normal operation. What it does:

• Produces the control panel's audible tones for end-of-cycle alerts and warnings.
• Replaces a buzzer that has stopped sounding or produces weak, intermittent, or distorted beeps.
• Helps restore audible error/fault notifications so you can respond to appliance alerts promptly.
• Works as the control panel's dedicated tone generator — pairs with the appliance's existing electronics.

• Disconnect power to the appliance before beginning any service to avoid electrical shock.
• Access the control panel per your model's service instructions and note wire/harness positions before removal.
• Disconnect the buzzer wiring or harness, remove mounting fasteners, and install the replacement in the same orientation.
• Reassemble panels, restore power, and run a test cycle to audible operation.

This genuine replacement part is a water valve for refrigerator ice makers. The water valve supplies water to the ice maker to fill the water reservoir. If the icemaker is no longer operating properly and no longer dispensing ice, it might mean that the water valve needs to be replaced. Thankfully, replacing this part is an easy repair. To begin, make sure all the power is turned off to the appliance. Open the freezer door where the water dispenser is located. Remove the inner panel of the door by unfastening the screws that secure it. Once the panel has been removed locate the old water valve and release it from its mounting brackets. Once removed, replace with the new water valve. Reinstall the door panel and restore power to the refrigerator. This OEM part is compatible with General Electric, Hotpoint, and RCA brand refrigerators.