Dryer Control Board

Fix a dryer that won't shut off or advance through cycles with this mechanical timer. Controls cycle sequencing and timing. Moderate DIY install.

This display assembly powers and visually reports the appliance control status so you can see settings and feedback on the control panel. It restores readable on-screen information and enables the front-panel display functions. What it does:

• Replaces the control-panel LCD and power/display electronics so the screen lights and shows information again
• Commonly used when the display is blank, dim, flickering or showing garbled characters
• Resolves unresponsive or intermittent front-panel display behavior tied to the display module
• Interfaces with the main control board to present time, temperature, and mode/status readouts

• One complete display assembly (power/LCD) as shown

• Disconnect power to the appliance before beginning any work to avoid shock
• Handle the LCD and cable connectors carefully to avoid damage; flexing or scratches can affect operation
• Access typically requires removing the control console or console bezel—keep track of screws and fasteners
• If symptoms persist after replacement, test the main control board and wiring harness for faults

If your dryer won't advance through cycles or stops mid-cycle, the mechanical timer may have failed. This part restores cycle selection and timing control.

This timer is the electromechanical control that sequences a washer's wash, rinse and spin cycles, restoring proper cycle advancement and timing for affected machines. Use this direct-fit replacement to regain reliable cycle control and predictable operation. What it does:

• Rotates through and switches washer cycle stages (fill, agitate, drain, spin) to control timing
• Replaces a worn or failed timer that causes cycles to stop, not advance, or skip functions
• Restores timed operation when a washer won't complete cycles or starts intermittently
• Interfaces with controls and motors to coordinate cycle transitions

• Disconnect power before attempting service to avoid shock or injury
• Access may require removing the control panel or console
• Retain all mounting hardware and note wiring positions; replace exactly as removed

Fix a dryer that won't heat, start, or respond to controls. This main electronic control board manages all dryer functions. Moderate DIY repair.

Fix a dryer that won't start cycles, shows error codes, or has an unresponsive display. This electronic control board restores timed functions and reliability.

Fix error codes or unresponsive controls with a new dryer electronic control board. Restores cycle selection and timing. DIY install in under 1 hour.

Dryer won't advance cycles or stops mid-cycle? This timer control regulates drying programs and cycle timing. Moderate DIY repair, 30-45 minutes.

Fix a dryer timer that won't advance or click during cycles. This mechanical rotary timer restores normal cycle selection. DIY-friendly, 20-minute repair.

Fix a dryer that won't advance or shuts off too soon with a new timer. Requires back panel removal and wire transfer. Moderate difficulty repair.

Dryer won't advance through cycles or stops mid-cycle? This timer control regulates your dryer's cycle progression. Moderate DIY repair for most models.

Dryer won't start or stops mid-cycle? This control board manages cycle timing and functions. Moderate DIY repair with proper safety precautions.

Fix a dryer that won't start, stops mid-cycle, or shows error codes with this electronic control board. Moderate DIY repair for most home models.

Fix a dryer that won't start, stops mid-cycle, or has no display with this control board. Moderate difficulty repair requiring basic hand tools.

Fix an unresponsive dryer control panel or blank display with this user interface control board. Restores normal display and cycle control functions.