Dryer Switch

This switch-plg is the OEM replacement plug switch that completes or interrupts the appliance's power connection, restoring reliable on/off control for the affected circuit. It fits where the original plug-style switch was used. What it does:

• Opens and closes the electrical circuit to allow or stop power flow through the plug-style connection
• Restores on/off control when a worn or failed plug switch causes intermittent power or a unit that won't power on
• Provides the same basic mechanical/electrical function as the original switch in the appliance's plug assembly
• Works as a direct replacement for the factory-installed switch-plg part

• Disconnect power (unplug appliance or shut off breaker) before removing or installing this switch
• Handle terminals carefully; secure terminal connections during replacement
• Compare the new part to the old part for correct orientation and fit before final assembly

A push-button signal switch that completes the user input circuit to the control board so selections register and the appliance responds to commands. Replaces a worn or unresponsive front-panel switch to restore reliable button operation. What it does:

• Sends the user's button press signal to the control board so commands are recognized
• Commonly replaced when front-panel buttons are unresponsive or intermittently work
• Helps restore proper cycle selection and control responsiveness
• Works as the user-input contact in the control/display assembly

• Disconnect power before starting repair to avoid shock or injury.
• Access the control panel per your model's service instructions; handle the display and wiring gently.
• Verify connector orientation and secure all harness connections before reassembling.
• Test operation after reassembly to confirm the new switch functions correctly.

The Push to Start Switch is an OEM component designed for Whirlpool electric dryers. Located on the control panel, the start switch initiates and stops each drying cycle upon button depression. Its electronic components coordinate power to the drum motor and other functions.

Symptoms of a bad start switch include:

• The dryer failed to start despite selecting the settings  
• Inability to cancel or pause cycles in progress
• Intermittent or unreliable response when pressing the button
• Lights or displays functioning but the drum remains motionless

Causes can involve normal wear over thousands of uses wearing out integrated circuits and connections. Water intrusion may lead to early failure.

This OEM Whirlpool part is also compatible with KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper, and Kenmore dryer models.