Electrolux Clip Or Clamp

Secures interior panels, trim, and rack components in your dishwasher. Replace when worn or broken to restore proper alignment and stability. Confirm fit with your model number.

Dishwasher mounting clip secures components in place. Replace if broken, loose, or missing to prevent rattling and ensure proper operation. Confirm fit with your model number before ordering.

Secure trim, panels, and wiring in your dishwasher with this snap-in retainer clip. Replace if components rattle or shift during operation. Confirm fit with your model number.

Secure dishwasher clip that holds components in place. Replace if broken, loose, or missing to prevent rattling and ensure proper part alignment.

Secures interior trim and panels in your refrigerator. Replace when trim becomes loose or rattles. Verify fit with your model number before ordering.

Secures and organizes wiring harnesses in your refrigerator. Replace if broken, cracked, or wires are loose. Confirm fit with your model number.

Secures trim, panels, and wiring harnesses in your laundry center to prevent rattling and shifting. Replace when clips crack or lose tension. Confirm fit with your model number.

Secures hoses and components in your dishwasher. Replace if cracked, loose, or causing leaks. Verify fit with your model number before ordering.

Secure solenoid clip for refrigerators. Replace if damaged, loose, or missing to ensure proper solenoid function. Confirm fit with your model number.

This small plastic clip secures the dishwasher drain hose to the pump assembly or discharge fitting, keeping the hose in place and helping prevent leaks or disconnection during operation. What it does:

• Holds the drain hose firmly to the pump or outlet fitting to maintain a watertight connection
• Prevents the hose from slipping free during drain cycles
• Helps stop water leaks and washing chamber flooding caused by a loose hose
• Useful when replacing a cracked or broken retaining clip

• One drain hose retaining clip

• Disconnect power and water supply before accessing the dishwasher lower access area
• Remove the access panel or kickplate to reach the drain hose and pump connection
• Use pliers or a flat tool to remove the old clip and snap the new clip over the hose/fitting until fully seated
• After installation, run a short drain cycle and inspect for leaks; re-secure if necessary

Secures dishwasher wire harness and prevents moisture from reaching the dispenser assembly. Replace if cracked, loose, or causing electrical issues.

Dishwasher clamp secures hoses and components in place. Replace if cracked, broken, or causing leaks. Verify fit with your model number.

Secures refrigerator hoses and tubing to prevent leaks. Replace if loose, cracked, or during water line repairs. Verify fit with your model number.