Electrolux Filter

The Drain Filter is an OEM component specifically designed for Frigidaire dishwashers. It is designed to trap food particles and debris from exiting the dishwasher and entering plumbing drains.

Causes of failure usually stem from normal wear and potential mineral deposits reducing pore size over many years of use. Hard water areas present additional stress. 

Symptoms of a clogged or ineffective drain filter include:  

• Slow or incomplete draining after cycles
• Gurgling noises from drain line blockages
• Potential plumbing backups and repairs from unfiltered waste

This OEM part fits Electrolux, Gibson and Kenmore models as well.

This replacement filter restores clear airflow through your appliance's venting system. It captures airborne particles so the fan can exhaust efficiently and helps protect internal components from buildup.

• Traps grease and other particulates in the air stream
• A clogged or damaged filter can reduce airflow and strain the blower
• Replace when torn, warped, or heavily saturated
• Common symptoms: weak venting performance, lingering steam/odors, visible residue on or around the filter

• Disconnect power to the appliance before servicing
• Access the filter from the intake grille or bottom panel and release the retaining tabs/screws
• Install the new filter in the same orientation; ensure it seats fully and locks in place
• Restore power and test fan operation on each speed

Filter only. Fine filter not included.

Replacement grill trim that restores your appliance's exterior finish and helps direct airflow. Use this grill when the original piece is cracked, missing, loose, or cosmetically damaged to regain a clean, finished appearance. What it does:

• Covers and protects internal components behind the appliance front or vent area.
• Helps direct airflow and reduce drafts around the appliance opening.
• Prevents debris or fingers from contacting internal parts.
• Stops rattling or vibration caused by a bent or loose grill.
• Restores the appliance's original look when the factory grill is damaged.

• Disconnect power at the breaker and allow the appliance to cool before starting any work.
• Remove existing fasteners or clips; retain original screws if they are reusable.
• Align the new grill, then secure with the original hardware; avoid over-tightening to prevent cracking.

A replacement refrigerator water filter that helps reduce taste and odor issues and improves clarity of drinking water. Fits inline into the refrigerator's water/ice system to restore cleaner-tasting water. What it does:

• Filters impurities that can cause off taste or odor in dispenser water and ice
• Helps reduce visible particles and cloudiness in dispensed water
• Supports proper water flow for the dispenser and ice maker when functioning correctly
• Commonly replaced when water tastes bad, smells, or appears cloudy

• Replace with manufacturer-recommended filter and follow refrigerator-specific instructions
• Turn off the water supply and dispense water briefly to depressurize before removing the old filter
• After installation, flush several gallons of water per manufacturer guidance to clear air and loose carbon
• Dispose of the used filter according to local regulations; check for any refrigerator-specific priming steps

This water filter manifold directs and seals the water flow to the refrigerator's filter housing so your dispenser and ice maker receive filtered water. Replaces a damaged or leaking manifold to restore proper water routing and pressure to the filter area. What it does:

• Channels incoming water into the filter housing and back to the dispenser/ice maker
• Provides mounting and a sealed connection point for the cartridge-style filter
• Commonly replaced for leaks, reduced water flow, or when the filter won't seat properly
• Works with the refrigerator's internal water plumbing and filter housing assembly

• One water filter manifold

• Turn off the refrigerator water supply and disconnect power before servicing
• Drain remaining water from lines and wear eye protection to avoid spills
• Inspect O-rings/seals and replace if damaged; hand-tighten fittings and avoid over-torquing

The Water Filter Bypass is an OEM replacement part for Frigidaire refrigerators. It provides an alternative water supply route to bypass the refrigerator's built-in water filtration system. The bypass allows refrigerator water and ice dispensers to operate without water flowing through the installed filter cartridge. 

Causes of a malfunctioning bypass can include mineral buildup inhibiting proper operation of the bypass valve, worn seals or O-rings not providing a tight seal or physical damage.  

Symptoms include:

• Inability to bypass the water filter when needed  
• Leaks from the bypass area
• The filter bypass not functioning or engaging properly

This OEM replacement is also compatible with refrigerator brands like Electrolux, Gibson, Kelvinator, and select Kenmore models.

Reduces contaminants and removes chlorine taste and odor to deliver clean and healthy water. It is certified by NSF International against NSF/ANSI Standard 42, Standard 53, and Standard 401 to remove other contaminants such as asbestos, atrazine, benzene and mercury. Easy push and twist install that requires no special tools. Filter should be replaced every 6 months or 200 Gal. to maximize contaminant reduction. Operating Pressure: 30-100 psi. Operating Temperature: 40-100°F. Flow Rate: .5 gpm.

A replacement PurePour pour-through funnel for refrigerator water-filter filling—helps channel water directly into the PurePour filter housing to reduce spills and ensure the cartridge fills and seats correctly. What it does:

• Funnels water cleanly into the PurePour filter housing to minimize splashing and wasted water.
• Promotes even filter cartridge filling so the filter can seat properly.
• Use when you notice water spilling, trouble filling the filter, or the filter won't seat securely.
• Works as the direct replacement component for the PurePour pour-through fill assembly.

• One replacement pour-through funnel.

• Turn off the refrigerator's water supply before removing or installing the funnel.
• Wipe the area dry and seat the funnel fully into the filter housing; no special tools typically required.
• Inspect seals and the filter cartridge for damage while replacing the funnel.

This refrigerator water filter cartridge reduces common water tastes and odors and helps protect your ice and dispense lines. It's a direct-replacement cartridge designed for easy swap-out to restore clearer, better-tasting water. What it does:

• Filters out chlorine taste and odor for improved drinking water flavor
• Captures sediment and particulate to help keep ice and dispenser lines cleaner
• Helps maintain normal water flow and clear ice when operating properly
• Fits inline with your fridge's water system to provide filtered water on demand

• Replace the cartridge according to your refrigerator owner's manual or when water taste, odor, or flow declines
• Flush system after installation per manufacturer guidance to remove trapped air and loose carbon fines
• Turn off water supply or follow appliance-specific safety steps before removing the old filter