Electrolux Parts

The Cord is an OEM replacement part for Frigidaire washing machines. Extending from the rear of the unit, it safely powers the washer through a connection to a wall outlet.

Causes of cord failure are normal wear from frequent coiling and plugging/unplugging motions over the appliance's lifespan. Rodents or sharp edges may also damage the outer jacketing.

Signs of a bad cord include:

• Exposed or severed copper wiring visible inside
• External cracks, splits or abrasions eroding the casing  
• Erratic behavior during the wash cycle
• GFCI/EGCI outlet tripping frequently

Compatible models also include Electrolux, KitchenAid, Jenn-Air, and Kenmore options. Maintaining safety is a top priority.

Replaces cracked or broken air flow deflector baffle inside your dryer drum. Guides internal airflow for proper ventilation and cooling performance.

Collects water from your refrigerator's defrost cycle and channels it to the evaporator. Replace if cracked, broken, or leaking underneath the unit.

Mounting screw for securing range panels, brackets, and igniters. Replace if stripped, missing, or damaged to restore proper fastening and alignment.

Refrigerator not cooling properly? A damaged or clogged condenser coil prevents heat rejection, causing warm temps. This assembly restores efficient cooling.

Electrical wiring harness that routes power between dryer components. Replaces damaged, frayed, or corroded harnesses with broken connectors or melted wires.

Replace a worn, broken, or missing washer cabinet damper to restore smooth counterweight action and controlled movement. Installs on cabinet assembly.

Rubber grommet cushions wiring, tubes, or panels in your dryer. Replace if cracked, worn, or missing to prevent chafing and reduce vibration noise.

Replacement mounting screw for refrigerator panels, brackets, and trim. Secures loose or missing fasteners to stop rattles and keep components aligned.

Metal or plastic channel that mounts and aligns refrigerator shelves or door bins. Replace if cracked, broken, or no longer securing shelves properly.

Replacement mounting screw for ovens and ranges. Secures panels, brackets, trim, and internal components. Replace missing or stripped screws to restore fit.

This is a black metal side panel that attaches to the left exterior side of the range, providing a finished appearance and structural support. It helps enclose and protect the internal components of the oven cavity. Replace this panel if it is dented, rusted, scratched, or damaged from heat exposure.

This blower assembly circulates air through the appliance to support proper airflow and heat distribution, restoring normal operation and efficiency when the original blower is damaged or failing. It replaces worn or broken blower components to reduce noise and improve performance. What it does:

• Spins the blower wheel to move air through the unit for proper heating, cooling, or venting
• Restores airflow when reduced air movement causes longer cycles or poor performance
• Reduces unusual noise from a wobbling or damaged blower wheel/housing
• Helps prevent overheating caused by restricted or ineffective air circulation

• Disconnect power (and gas if applicable) before starting any repair
• Access typically requires removing exterior panels or the front panel; use basic hand tools
• Inspect and clean surrounding airflow paths and vents of lint or debris while replacing the blower

Connects the turntable motor to the rotating glass tray in your microwave. Replace if the coupler is cracked, broken, or missing and the tray won't rotate.

Cushion bumper for washer installation. Absorbs vibration and protects cabinet surfaces. Replace if cracked, compressed, or missing to restore proper support.