Frigidaire Clip Or Clamp

Secures dishwasher components in place. Replace if clips are broken, cracked, or loose causing rattling or misalignment. Verify fit with your model number.

Secures the blower housing in your dryer. Replace if broken, loose, or causing rattling noises during operation. Verify fit with your model number.

Secures trim, panels, and wiring harnesses in your laundry center to prevent rattling and shifting. Replace when clips crack or lose tension. Confirm fit with your model number.

Secure refrigerator components with this retainer ring. Replace if damaged, cracked, or causing parts to loosen. Verify fit with your model number.

Used to hold the original electrical components to the side of the compressor.

Secures the front grille on your refrigerator. Replace if broken, missing, or grille is loose. Verify fit with your model number before ordering.

Secure solenoid clip for refrigerators. Replace if damaged, loose, or missing to ensure proper solenoid function. Confirm fit with your model number.

Secures components inside your refrigerator. Replace if broken, loose, or missing to prevent rattling and ensure proper part positioning. Verify fit with your model.

Dishwasher fastening clip secures internal components like racks and panels. Replace if broken, loose, or missing to restore proper fitment. Verify compatibility with your model number before ordering.

Secure dryer hose clamp prevents air leaks and improves venting efficiency. Replace if loose, damaged, or during hose maintenance. Confirm fit with model.

This small plastic clip secures the dishwasher drain hose to the pump assembly or discharge fitting, keeping the hose in place and helping prevent leaks or disconnection during operation. What it does:

• Holds the drain hose firmly to the pump or outlet fitting to maintain a watertight connection
• Prevents the hose from slipping free during drain cycles
• Helps stop water leaks and washing chamber flooding caused by a loose hose
• Useful when replacing a cracked or broken retaining clip

• One drain hose retaining clip

• Disconnect power and water supply before accessing the dishwasher lower access area
• Remove the access panel or kickplate to reach the drain hose and pump connection
• Use pliers or a flat tool to remove the old clip and snap the new clip over the hose/fitting until fully seated
• After installation, run a short drain cycle and inspect for leaks; re-secure if necessary