Frigidaire Clip Or Clamp

Secures motor wiring in your refrigerator. Replace if adhesive fails or clamp breaks, causing loose wires. Confirm fit with your model number.

Secures electrical contacts to your refrigerator compressor. Replace if loose, damaged, or causing electrical connection issues. Verify fit with your model.

A small spring-style hose clamp that secures appliance hoses and tubing to fittings to help prevent leaks and hose separation. Simple, durable clamp replacement for worn or damaged hose connections. What it does

• Holds rubber or plastic hoses firmly on barbed fittings to maintain a sealed connection.
• Helps stop water or air leaks caused by loose or deteriorated hose attachments.
• Reduces movement and rattling at hose connection points during operation.
• Commonly replaced when clamps are corroded, stretched, or no longer spring-tight.

• Disconnect power and water supply before servicing the appliance.
• Use pliers to open the spring clamp, slide into position, then release so it seats evenly around the hose.
• Inspect the hose and fitting for damage; replace hose if cracked or brittle.
• Wear eye protection and gloves; ensure clamp sits behind the hose barb for a secure seal.

This small spring clip secures the oven bake/hidden element to the range housing, keeping the heating element properly positioned for consistent operation and preventing movement or rattling during use. What it does:

• Holds the oven element in place at the mounting bracket so the element stays aligned
• Prevents the element from shifting, vibrating, or making contact with other components
• Helps maintain a stable electrical and mechanical connection at the element mounting point
• Commonly replaced when clip is broken, bent, or missing and the element won't stay seated

• One spring mounting clip

• Disconnect power to the appliance before beginning any repair to avoid shock or injury.
• Access usually requires removing the oven bottom, back panel, or element mounting bracket—support the element while removing/installing clips.
• Use gloves and eye protection; clips are spring-loaded and may release suddenly.
• Replace only the clips that are broken or missing; fit before restoring power.

This cable tie secures wiring and small hoses inside the appliance to prevent rubbing, snagging, and vibration-related movement. It's a simple replacement part for restoring proper wire routing and keeping components tidy and safe. What it does:

• Holds wiring harnesses and loose cables in place to reduce wear and chafing
• Helps prevent wiring from contacting hot or moving parts
• Reduces noise caused by loose wires or hoses
• Keeps connectors and lines routed for reliable operation

• Disconnect power to the appliance before servicing
• Route wiring as shown in the appliance wiring diagram or photos, then cinch the tie snugly—do not overtighten
• Trim excess tail and ensure the tie does not stress the wire insulation
• Replace any damaged wiring or insulation discovered during installation