Ice Maker & Related

Ice maker won't stop making ice or overflows? This shut-off arm controls ice production by signaling when the bin is full. Simple DIY fix for most models.

This ice ejector is the plastic arm that pushes cubes out of the ice maker mold and into the ice bin, restoring proper ice ejection and dispenser function. It's a direct-replacement component for affected ice maker assemblies. What it does:

• Physically strips and pushes formed ice cubes from the mold into the bin or dispenser
• Helps restore normal ice dispensing when cubes remain stuck in the mold
• Works with the ice maker's motor/gear train to time ejection during the harvest cycle
• Commonly replaced when the ejector is broken, cracked, or worn and no longer contacts cubes

• One ice ejector (ejector arm)

• Disconnect power to the refrigerator before starting any repairs
• Remove the ice maker/cover or access panel as required to reach the ejector
• Inspect related components (drive gear, motor, and mounting pins) for wear while replacing the ejector
• After installation, run a test harvest/dispense cycle to correct operation

Fix no ice production or leaking ice maker with this mold assembly. Common when water doesn't fill properly or ice freezes together. Moderate DIY repair.

Ice sits on top and won't fall into bin? This ice maker stripper pushes cubes into the collection bin. Simple DIY repair, just remove and replace.

Ice maker not ejecting ice cubes properly? This stripper arm restores correct movement and alignment in your refrigerator's ice maker. DIY-friendly repair.

Ice maker won't stop making ice or overflows? This refrigerator ice maker shut-off arm controls ice production. Direct replacement part for most models.

Ice maker won't stop making ice or overflows? This shut-off arm controls ice production in your refrigerator. Direct replacement part for common issues.

Ice maker not dispensing cubes or producing hollow ice? This ice maker ejector controls the ice release cycle. Moderate DIY repair for most models.

Ice maker producing misshapen cubes or not freezing properly? This ice mold tray forms and shapes individual cubes in your refrigerator's ice maker assembly.

Need a convenient way to serve ice? This refrigerator ice scoop fits the ice bin perfectly with a comfortable handle for easy dispensing and serving.

Ice maker not ejecting cubes or jammed? This ejector arm controls ice cube release from the mold. Common fix for ice production issues in minutes.

This ejector arm sweeps across the ice maker mold to push finished ice cubes out and into the storage bin. It is a dual-arm design for an 8-cube ice maker tray. Replace this part if ice cubes are not being released from the mold, the arm is bent or broken, or the ice maker is cycling but not dispensing ice into the bin.