Ice Maker & Related

Ice maker not working or frosting over? This protective cover shields the control module from debris and moisture. Easy 30-minute DIY installation.

Ice cubes stuck in tray or not releasing? This ice mold and heater assembly warms the tray during harvest to release cubes cleanly into the bin.

Ice spilling inside freezer or dispenser not working? This ice container deflector guides cubes into the chute. Simple snap-in installation fix.

Ice not dispensing or clumping in your freezer? This ice container assembly holds and feeds ice to the dispenser. Replaces cracked or worn bins.

Ice bin cracked or warped? This container stores ice from your icemaker and guides cubes to the dispenser. Simple plug-and-play replacement part.

Ice maker not producing cubes or stopped working? This complete ice maker assembly restores automatic freezing, harvesting, and shutoff. Typical DIY repair.

Ice dispenser clogging or container rusting? This refrigerator ice bin catches and stores ice from your icemaker. Direct replacement takes 15 minutes.

Fix a refrigerator that stopped making ice or won't release cubes. This automatic ice maker assembly restores ice production. Direct replacement part.

Fix a refrigerator that stopped making ice with this ice maker kit. Replaces broken assembly that won't freeze, fill, or eject cubes properly.

Used to prevent over ice production in the ice dispensing bucket.

Lost or broken ice scoop? This replacement scoop fits your refrigerator's ice bin perfectly. Simple snap-in installation takes just minutes.

Ice won't dispense or bucket feels loose? This ice bucket assembly collects and stores ice, includes auger and crusher. DIY-friendly replacement part.

Freezer stopped making ice? This ice maker assembly restores automatic ice production. Connects to existing water supply and wiring for reliable operation.

Ice maker won't stop making ice or overflows? This shut-off arm controls ice production by signaling when the bin is full. Simple DIY fix for most models.

Ice maker not shutting off or making too much ice? A worn lever arm prevents proper shutoff. Simple replacement takes under an hour to restore function.

This ice ejector is the plastic arm that pushes cubes out of the ice maker mold and into the ice bin, restoring proper ice ejection and dispenser function. It's a direct-replacement component for affected ice maker assemblies. What it does:

• Physically strips and pushes formed ice cubes from the mold into the bin or dispenser
• Helps restore normal ice dispensing when cubes remain stuck in the mold
• Works with the ice maker's motor/gear train to time ejection during the harvest cycle
• Commonly replaced when the ejector is broken, cracked, or worn and no longer contacts cubes

• One ice ejector (ejector arm)

• Disconnect power to the refrigerator before starting any repairs
• Remove the ice maker/cover or access panel as required to reach the ejector
• Inspect related components (drive gear, motor, and mounting pins) for wear while replacing the ejector
• After installation, run a test harvest/dispense cycle to correct operation