Need Help?
Call or text
Oven door hinge supports the door and allows smooth opening and closing. Replace if cracked, broken, or if door sags or won't stay in position.
I replaced the hinge due to the hinge spring breaking. To replace the hinge you do the following: 1. Disconnect power to stove, either at circuit box or at outlet. 2. Lift door off of outside hinge arms ; no screws are used to attach the door to the hinge 3. Remove two screw on under side of cook top, one on each side. 4. Disconnect cook top connector. 5. Lift cook top off 6. Remove screws from top rail of stove that hold the side panel. 7. Remove the screw on the back that hold the side... Read more
Left-side oven door hinge that supports and controls door movement. Replace if hinge is cracked, broken, or door won't close flush, allowing heat to escape.
The replacement hinge unit arrived in just two days. The JennAire (Maytag) oven door is fairly typical in that it easily lifts off of the hinge bars. Once the door is off then removing two screws is all that's required to remove the hinge unit from the oven. The new hinge slides up into place and while you hold it up inside of its location putting the old screws back in is very easy. After sliding the door back down onto the hinge bars the oven is as good as new Read more
Replaces a cracked or worn door hinge bushing on bottom-mount and French door refrigerators. Ensures smooth door operation and proper alignment.
The right door on our Jenn Air French Door Refrigerator would pop open & not fully close when the left door was closed first. Called the local distributor/dealer who advised me that the magnetic door gasket probably needed replacement (cost $300.00 + for the repair) What??? Visited you web site where I noted the right door had a "closure & bushing" on the bottom of the door. Could it be this was the problem fix? Took the right door off & examined both pieces. Sure enough the bushing was... Read more
Replacement hinge that supports and controls your oven door movement. Install if your hinge is cracked, springs are weak, or door won't align properly.
Removed oven door, took door apart replaced oven hinges. Pulled oven out of recess to access hinge receptacle. Replaced hinge receptacle. Read more
Grey cam riser for refrigerator door hinge assembly. Replaces worn or broken cam that supports door alignment. Essential for door self-closing function.
My Whirlpool refrigerator model GSS26C4XXF03 door wouldn’t swing shut all the way like it used to. So I changed the two lower cams. This cam #WPW10257203 was a perfect match but I needed to change the matching cam on the hinge, also, which require some modification to fit (I ordered cam #W11311687). The whole thing would have taken less than 15 minutes if I didn’t have to modify the other cam. Read more
Limits refrigerator door travel to prevent overextension and cabinet damage. Replace if cracked, broken, or worn to restore controlled door movement.
Replaced door closure and door stop. Read more
Replaces worn or broken refrigerator door closer cam that installs at the bottom hinge. Restores smooth door action when the original is cracked or damaged.
Watched the video at Appliance Parts Pros. Followed the video. I was fixing the refrigerator door (a little easier then the freezer door). The repair was very simple and took less then 15 minutes. Read more
Supports and pivots your oven door for smooth opening and closing. Replace this hinge if worn, broken, or causing door misalignment issues. Installs inside oven.
Oven door had been acting up for years (difficult to close). One of the hinges finally broke, so I ordered a replacement. Installation was about as easy as it gets. One trick: FIRST get a paperclip (or small nail or something similar) and put it through the hole in the existing hinge that you are not replacing to keep the hinge from retracting all the way later when the door is removed. If you don't, the hinge could pinch your finger or hand when the door is removed and it snaps closed. At a... Read more
Replacement hinge for range oven doors. Sold individually; doors use two hinges. Replace if door won't stay closed, drops too fast, or is misaligned.
I had to take out the bottom drawer that holds pans. Disconnect the power and pull the oven out. Removed door, rear panel that held the screws for the side panel and lift up and out the side panel. After that it was straight forward as to replacing the hinge. Spent more time cleaning the florr where the oven was than installing the hinge. Read more
Replacement door hinge for refrigerators. Installs on the top or bottom of the door to allow smooth opening and closing. Needed when broken or cracked.
Upper door hinge for gas wall ovens with side-swing doors. Replace if hinge is cracked, spring is broken, or door won't align or seal properly.
I REPLACED THE HINGE ASSY ONLY BECAUSE I WAS UNABLE TO PURCHASE THE SPRING ONLY. THIS IS 3rd TIME I REPLACED THE HINGES BECAUSE OF A BROKEN SPRING. IT WOULD BE CHEAPER IF ONLY THE SPRING COULD BE BOUGHT. Read more
Mounts to the bottom hinge to limit door swing angle. Replace if your refrigerator door opens too far, hits the wall, or the bracket is bent or broken.
First part ordered using chat assistant did not fix problem, spoke to technician who refunded first part and ordered another part. second part fixed problem. Read more
Mounts at the bottom hinge to raise and lower the refrigerator door as it swings. Replace if cracked, worn, or broken to restore smooth self-closing.
White plastic bushing that sleeves the hinge pin where your refrigerator door pivots. Replace when cracked, worn, or missing to restore smooth door swing.
Purchased new hinge bushing, door closer, and hinge pin. Read more
Mounts at the upper corner of the cabinet to support and pivot the refrigerator door. Replace if bent, cracked, or missing to restore door alignment.
A friends family had left her refrigerator out on a porch while they were remodeling the house she was supposed to move into. A wind storm blew the refrigerator off the porch and tore the door off. It wasn't dented at all, but when her son pu the door back on, it wouldn't seal. She asked for some help fixing it. I ordered replacement parts for the upper and lower hinge. The parts arrived quickly. I unscrewed the top hinge which was slightly bent. Set the door on its side and replaced the bent... Read more
Door hinge receiver for wall ovens. Mounts inside the oven frame to hold the door hinge in place. Replace if cracked, deformed, or causing door alignment issues.
I was able to order new hinge receiver brackets for the door. The repair was not that bad. I just had to take off the lower door, take the two trim pieces off the sides and unscrew the screws holding the oven into the face of the cabinet. Then slide it out about halfway and put a step stool under the front to keep it from tipping over. Then it was just a matter of taking off everything around the sides until I could take the brackets off, put the new brackets on, and put everything back... Read more