Kenmore / Sears Gasket & Seal

Ordered new seal and the correct adhesive to use and followed directions for resealing of the door. Read more

I ordered the dispenser and the distribution nozzle since the old one was in bad shape. I also replaced the boot since I had to take the entire machine apart and it is 20 years old. I watched your videos on you tune to learn what to do. I recently lost my job and really could not afford to hire someone to fix my washer. I have to say it wasn't that hard to do and my wife was so happy that I was able to fix it myself! I probably saved $200 or $300 in service calls and labor on top of what they... Read more

Ordered a new seal and the install was fairly easy. Read more

I replaced the freezer door seal. Read more

Hearing a metal on metal noise and not actually circulate water cancelling cycle worked fine After some web research, I concluded it was highly likely to be the circulation pump, so I watched the video on AppliancePartPros.com and realized it was a lengthy repair (a lot of steps) but not technically difficult. I simply played and paused the video at each step and duplicated the steps. The biggest things to take note of: 1) take good pictures of the wiring to use when you re-connect. 2) Wear... Read more

Turned out that the large gray boot/gasket had finally started to harden and deteriorate right at the bottom where the drain hose is. No surprise it leaked after seeing that. Installing the new gasket (and new clamps which I figured I would replace at the same time) did the trick. Fairly simple install. Do yourself a favor and buy the spring pliers to remove/install the clamps. Well worth the time and hassle they will save you. Read more

Instructions are very dumb, but it's an easy fix. Loosen all the nuts that hold the metal bars that hold the old gasket. (Loosen. Don't take them off!) Pull off the old gasket. Slip the new into place all the way around. Get the corners in position, middles can be loose. Tighten the corners, then work the middles into place and tighten as you go. Done. Read more

Ordered the parts from this parts site and the wife and I replaced both. Working great! Read more

I replaced the gasket Read more

Put in missing o-ring Read more

• Door sweating

Replaced gasket. The short tutorial on replacing gaskets was a great help. Read more

Replace the gasket, very simple Read more

I replaced the door boot with a new one from AppliancePartsPros.com. The most difficult part was starting at the back end of the new boot onto the stationary rim, just in front of the tub. And then anchoring it in place with the existing spring from the previous boot. To start the boot I had to hook the top edge of the boot, where the arrow tab is, onto the rectangular projection on the tub rim and then roll the rubber boot edge down around the tub rim and hope the rim was going into the... Read more

Watched You tube videos to narrow the problem down to old deteriorated gaskets. Read more

Easy just pull clip and put back Read more