Kenmore / Sears Gasket & Seal

• Door sweating
• Fridge runs too long

Loosened nuts around outer flange. Pulled out old gasket as shown in video. Prepared new gasket per included instructions. Installed new gasket again using techniques shown in video. Secured nuts then confirmed proper seal. This was not a difficult repair however patience and care is needed to ensure new gasket is properly seated without damage. Read more

I replaced the old control panel with a new one. I also changed out the door seal to help prevent the control panel from going bad a second time. It was the heat from the oven getting to the keypad on the control panel that caused it to go bad. Read more

Repair was very easy. No instructions included but basically start the new seal tabs at the bottom in the middle and work your way around snapping in place. 60 seconds Read more

Replaced it with a new gasket from your company Read more

It was so simple, parts pulled out and installed the new parts 10 minutes very easy Read more

Took out the old gaskets put the 2 new ones in and it was all a simple project. Couldn't be easier. Read more

This was more maintenance than a fix. I replaced the door gasket and temp sensor on my dryer. Thought what the heck and it might work more efficiently. I also replaced the shocks on my front loading washer. That was a bit of a chore, but could not have done it without the video that showed how to replace them. The socket was the life saver. All is working just fine. Who knows maybe I'll get another 20 year out of them. Read more

I used the parts recommended by the parts diagram.. Read more

• Freezer section too warm

It was bad at all I was able to get it done in about 1 1/2 I had to unscrew the nuts and place new gasket and the place new gasket and put back the nuts Read more

• Door sweating

I called Appliance Parts Pros and gave them the model number of my refrigerator. They promptly advised me exactly what part I needed, told me the price and cost of shipping. I agreed and received my part within 2 days. I watched the video that told me exactly how to complete repair. It was very simple. The only thing different was that there was a metal strip holding the gasket in place. Removing it was no problem. When I installed it I had to loosen the screws? nuts? slip the gasket... Read more

• Leaking

Since the fridge was an older model, it had screws behind the gaskets. First, I removed the freezer door, then I loosened the screws and removed the old gasket. I then placed the new gaskets, corner first, then worked my way around the door until all sides was done. I tightened the screws. For the lower door, I didn't remove the door but I removed all items from the door shelves. Loosened the screws, removed the old gasket, then placed the new gasket one corner and worked my way around the... Read more

I watched AppliancePartsPros.com videos and went for it. Made it easy. Read more