Kenmore / Sears Parts

My Kenmore washer had three problems and thanks to AppliancePartsPros.com videos I was able to repair all three. The washer coupler was defective so I replaced it. This topok about 30 minutes. The washer lid switch was defective. This took about an hour. Finally, the motor was defective. I was able to disconnect the motor from the transmission and test the motor by leaving the wiring connected and run a wash cycle. The motor was dead. I replaced it with a new motor and now the washer runs... Read more

Technician wanted $700. I was able to fix it myself for around $300 in about a half hour with the great and helpful customer service of appliancepartspros.com. Parts arrived on time. Nice to know there is a company that really cares and they know there stuff. Read more

Looked online and found that someone had experienced the same issue and had replaced the cooling fan assembly for the magnetron. I ordered the parts for the assembly (motor, fan, and support), and replaced them and this fixed the problem. It took about 10 minutes to replace the parts, but lowering the unit and disassembly took around 45 minutes. The most difficult part was getting the outer sheet metal cover back on after the repair, as it has a bunch of clips on each front edge that need to... Read more

Very easy fix. Turned of power at breaker. Removed oven door by lowering two "keepers" on the hinges for the oven door and sliding the door out of the oven. Removed the trim plate at bottom of oven by pushing it up.. Removed 2 screws that mount to the frame of the cabinet at the bottom that the trim plate hangs from. Then removed 4 screws that hold the oven into the cabinet at either side of the oven. Put two 5 gallon buckets in front of the oven and slid the oven out onto the side-by-side... Read more

Started out as a replacement of the coupling between the motor and the basket transmission ( 2 of the 3 legs on the transmission side broken.. )... Bought a new pump, since I would have it off... or so I thought.. Metal output shaft into pump + years of moisture = pump rusted on. Put it all back together - runs fine... for a while.. Then the old pump bearings burn out. Back apart.. Cut the old pump off the motor. Reinstall everything... Nothing, Just sits there and buzzes... Now... Read more

• Noisy

Used Google to troubleshoot the issue. Inside the freezer I took the back off. Noticed two things. The evaporator motor was not turning and the top half of the coils were frozen over. Obvious fan not spinning issue. I felt the motor and it was hot. Spun the fan it it started spinning. Put it all back together. Ran OK for 5-6 more days then same issue. I ordered the new motor and then and spun the fan again. It lasted for 2 days. Had to spin the fan to get it going 2 more times until... Read more

I watched videos on the website and took it apart. Put new motor on, also I put new belt even though the original belt was still ok, but I saw a little sign of shredding ...and there! !! It works like brand new washing machine. . Thanks to appliancepartspros.com...It made save a lot of money by doing it myself.. Read more

I replaced the downdraft fan and fan motor of my 25 year old JennAire C301 cooktop. The issue was getting the fan/motor assembly out in such a tight place. I had to first remove the fan cover, cut the wires, then the assembly came out. Putting back wasn't as tough although getting the cover back on (over the motor) was a bit of a strain. Wired it back, turned it on, and was thrilled. Now I'll replace the knobs and burners and we're back in business. Read more

I replaced the motor. It was time consuming because you have to take all of the parts that attach off. Was fairy simple. Pleased about the parts delivery. Ordered and received the next day. Read more

REPLACED THE FREEZER EVAPORATOR MOTOR. PART WAS CORRECT ONE AND FIT GREAT! Read more

I took the easy fix first and replaced the Capacitor. That got me three loads before the motor burned out. I ordered the motor from AppliancePartsPros.com after a google search for "best price model # 134159500 Drive motor " The part arrived in 5 days, and it took about 15 minutes to remove the old motor and replace it with the new one. Simple and easy. four screws, four nuts, and two electrical connections. — The hardest step was one of the four mounting screws was way back inside and it took... Read more

Replaced rotor and stator Read more

I found several "threads" on my google search which indicated that it might be caused by a non-functional condenser fan. I removed the back bottom panel and voila, the fan was not spinning even though the compressor was running and felt very hot. If I spun the blades, the fan would run, but as soon as the compressor shut off, it would not start up again without my help. The replacement part was easy to find at AppliancePartsPros.com. I ordered it and had it within 48 hours. I didn't even need... Read more