Kenmore / Sears Parts

Removed freezer door by removing 4 bolts holding slide tracks for freezer basket. Pulled out old gasket. Soaked new gasket in hot water to smooth out a crease that resulted from shipping. Installed new gasket, starting at corners. Used a blunt tool to push new gasket into slot at the corners. Set remaining gasket material with hands. Used putty knife to tuck edge of gasket under lip along door. Reinstalled door. Take care to line up door perpendicularly. There is some play when... Read more

• Element will not heat
• Won't start

The receptacle that held the burner element in place was broken so the burner would not make a connection and heat up. I ordered the receptacle kit. There was even an online video that showed how to make the repair. It just took a screwdriver and wire cutters and about 15 minutes and the job was done. The burner works great. Read more

Installed new agitator Read more

With your part thanks Read more

Replaced with no problem. Exact fit. Less than 5 minutes. I will order from your company again. Arrived on scheduled date. Read more

• Not dispensing water
• Ice maker dispenses too little ice
• Ice maker won't dispense ice
• Ice maker not making ice

Ordered part and replaced it Read more

Looked up parts based on fridge model number, watched videos, and replaced parts using just a few tools... easy. Parts came quick, well packaged. After 16 years, plastic parts deteriorate and break. The fridge was operating fine, but the drawers and covers were failing. Much cheaper to replace a few parts ($$-$$$) than buy a new fridge ($$$$). The new parts matched up exactly to old ones. The videos were very helpful, but not perfect... for the Crisper Frame, there was a structural metal... Read more

I watched the video that was shown on this website to slide the top back, remove the control panel, remove the front panel of the washer, remove the old gasket (the two tension springs are easy to get off, not as easy to replace), cleaned out years of gunk and soap that had built up behind the gasket for 10 years as well as under the rollers in the drum (each roller has a screw, remove it, slide the roller assembly forward and lift up to take off the rollers, and the roller can be broken down... Read more

Watched the attached video, then followed directions and installed the part ordered. Read more

Remove upper and lower baskets for access. Remove 4 Torx screws holding drain/filter assembly, accessing last screw by rotating the water duct clockwise. Be sure to first un-clip the water duct at top and rear of dishwasher so that it can be moved. (Take the opportunity to remove accumulated deposits behind the water duct). Remove the drain/filter assembly and then remove the single screw holding the food chopper housing. Then remove the chopper assembly which is likely to be in pieces if it... Read more

• Leaking

I had previously replaced the pump about 1 year ago. That was not the problem. Still leaked the same way - intermittently, but always in the center of the washer onto the floor. None of the hoses were leaking - no evidence of corrosion or water mineral residue at any of the hose fittings. So, it must have been something else. I studied the parts diagram for the washer tub assembly and concluded the source of the leak almost had to be the outer tub's Centerpost Gasket. It was really the... Read more

• Too warm
• Doesn't shut off
• Fridge runs too long
• Freezer not defrosting

Fixed it by replacing the electronic control board. Only 30 min. to fix. (See further down for effort to diagnose the problem.) Most of this "fixing time" was spent removing the control panel to access the control board that is attached to it. My freezer has the control panel located in the top center of the door. The only way to remove the control panel is to pry the panel out of the door using a thin-bladed putty knife.The instructions provided were very good in explaining the process;... Read more

Removed crisper pans and removed the cover. installed the new cover, replaced the pans. That quick and that easy! Being an older frig, this new cover was made a little different, however fit perfactily. Read more

Ordered a new one. It took about 10 seconds to install. Now it’s like brand new. Read more

• Oven is too hot
• Little to no heat when baking
• Won't start
• Little to no heat when broiling

First of all Appliance Parts Pros is the best!! I would not have had the confidence to make this repair myself without their outstanding videos and Q&A sections on their website. And their prices for parts are very competitive. Like many stories on the website, my oven would heat up beyond the temperature set point. When it reached the target temperature, the lower heating element (I think this is the “bake” element) would shutoff, but the top element (“broil” element I believe) would remain on... Read more

After researching on the APP site, I decided what I thought I would need and purchased a new Gasket, Gasket Insert, Left & Right Corner Baffles from APP. The parts were shipped immediately. However, I’m an 80 yr. old female so I procrastinated for almost 6 weeks before deciding to 'tackle' the repair myself rather than hiring an appliance repair person or "handyman". I went back into the AppliancePartsPros site and reviewed the wonderful videos related to the repair since Matt had made it... Read more