Kenmore / Sears Switch

Washer won't fill properly or overfills? This water level pressure switch senses water height and signals the control to stop filling at the right level.

This is a 7-position temperature selector switch that mounts on the washer's control panel and allows you to choose the water temperature for each wash cycle. It controls the mix of hot and cold water entering the tub. Replace this switch if your washer fills with the wrong water temperature, only uses hot or cold regardless of the setting, or if the temperature dial no longer clicks into position.

This wiring harness assembly routes power and signals between the appliance control and electrical components so the unit operates reliably. It replaces a damaged or burnt harness to restore proper electrical connections and reduce intermittent faults. What it does:

• Connects controls, switches and motors to the main power and control board
• Restores interrupted circuits that can cause intermittent operation or component failure
• Helps resolve symptoms like lights, fans or motors not running or responding
• Replaces frayed, melted or corroded wiring that creates shorts or open circuits

• Disconnect power to the appliance before servicing to avoid shock or injury
• Handle connectors by the plug bodies; avoid pulling on wires
• Route and fasten the harness exactly as the original to prevent chafing or heat exposure

Range burners won't light or clicking but not igniting? This igniter switch controls spark ignition for reliable burner lighting. Moderate DIY repair.

This switch controls the power to a cooktop surface element, allowing you to adjust the heat level. It connects to the element's wiring and regulates the electrical current that heats the burner. Replace this switch if a surface element won't turn on, stays on one heat setting regardless of the knob position, or does not shut off properly.

Compactor won't run unless you hold the dial? A worn safety switch actuator prevents proper door latch engagement. This repair restores automatic operation.

Hood lights or fan won't turn on? This rocker-style switch restores on/off control when buttons fail or work intermittently. Direct-fit replacement.

Range burner not heating or temperature won't adjust? This surface element control switch regulates heat output. Moderate DIY repair in 30-45 minutes.

Burner won't heat or turn off? This infinite switch controls surface element temperature. Common fix when a burner stops working after replacing the element.