Lg Damper & Related

The Damper Bracket is an OEM component for LG microwaves. Located inside the microwave cavity above the wave stirrer, this bracket holds the position of the damper assembly that helps distribute heat evenly during cooking. The bracket measures approximately 12” by 5”.

Symptoms of a bad damper bracket can include:  

• Hot or cold spots developing within the microwave cavity
• Looseness in the damper assembly fit
• Reduced heat circulation leading to uneven cooking

Causes typically consist of cracking over long-term heat exposure. Repeated opening/closing of the damper may also weaken attachment points on the bracket.

This OEM LG part is also compatible with Sears/Kenmore microwaves. 

The Damper is an OEM component for LG microwaves. Located within the cooking cavity, it regulates airflow and safely vents steam escaping heated foods. 

Causes of a faulty damper can involve standard wear and exposure accepting steam and condensation release. Food or liquid particles drying within tracks also threaten eventual adhesion issues restricting travel if left unaddressed between cleanings.

Symptoms of a damaged or defective damper include:

• Inability to adequately vent excess moisture from heating  
• Potential messes spilling beyond the microwave frame  
• Grating sounds or squeaks emitting during cooking
• Flaps possibly stuck inhibiting steam circulation 

This damper is also compatible with Kenmore microwaves as well.

This damper assembly controls airflow between refrigerator compartments to help maintain set temperatures and even cooling. Replaces a failed or stuck damper to restore proper air distribution and temperature balance. What it does:

• Regulates airflow between compartments so cold air moves where needed
• Can stop stuck-open or stuck-closed airflow that causes uneven temperatures
• Often linked to symptoms like warm spots, inconsistent cooling, or temperature swings
• Help reduce excess frost or humidity issues caused by improper airflow

• Disconnect power to the appliance before starting any repair
• Access usually requires removing interior liners, shelves, or panels; follow the service manual
• Handle actuator and wiring carefully; avoid pinching wires when reinstalling

This air tunnel directs heated air from the blower assembly into the dryer drum to maintain proper airflow and drying performance. Replaces a cracked or damaged duct to restore efficient air circulation and reduce drying time variability. What it does:

• Channels warm air from the blower to the drum for consistent drying and heat distribution
• Helps maintain proper venting and prevent hot spots that can cause uneven drying
• Commonly needed when cracks, breaks, or blockages cause poor airflow or extended dry cycles
• Contributes to normal operating airflow; damaged tunnels may lead to longer run times or reduced efficiency

• Disconnect power to the appliance before beginning any repair
• Access typically requires removing the dryer's front or rear panels
• Inspect surrounding seals and fasteners; replace any broken clips or gaskets to ensure a proper seal
• If you smell burning or see significant lint buildup, clean the lint and vent system before reassembly; consider a full vent inspection