Need Help?
Call or text
Black grille that sits at the base of your refrigerator's ice/water dispenser to catch drips. Replace when cracked, stained, loose, or missing.
Bought a replacement overflow grille. Read more
Soap or rinse aid dispenser not opening? This wax motor actuates the dispenser door release. DIYers report 15-30 minute repairs with basic tools.
I found the videos on dishwasher repair that AppliancePartsPros offers and determined the likely cause of the problem. I removed the door cover and found soap caked on the back. I cleaned the cover and switched the wax motors to see if the clean rinse motor was good and ran a tested cycle. No improvement. I ordered two new wax motors for the Maytag dishwasher and those arrived in a few days from AppliancePartsPros. I replaced the old motors and ran a test cycle. The soap tray opened correctly.... Read more
Fix detergent not dispensing or drawer leaking issues with this washer dispenser drawer assembly. Holds detergent and fabric softener during wash cycles.
Covers and protects the ice container in your refrigerator. Replace if cracked, broken, or missing to keep ice fresh and prevent contamination.
Fix detergent leaking or improper dispensing with a new washer dispenser drawer. Replaces cracked or worn 3-compartment drawers. Easy DIY repair.
Order new drawer dispenser and install. Read more
Fix additives not dispensing or standing water in the drawer with this siphon insert. Restores proper bleach and softener flow. Simple 5-minute repair.
White overflow grille for refrigerator water/ice dispenser. Replaces cracked, pitted, discolored, or missing grilles. Snaps into place below dispenser.
Gas insurance won't fix dispensing mechanism. Went to Youtube and watched video. Googled appliance parts, you looked reputable and took paypal. Ordered parts, repair took about 10 minutes. Thank you Read more
White plastic grille that sits beneath the ice and water dispenser to catch drips and spills. Replace if cracked, stained, or missing for a clean look.
The new Ui assembly that has all new push buttons. I found the water shutoff and the power plug when we pulled the fridge out. I shut off the water and pulled the AC plug. The whole assembly that is being replaced, came out easily when I pushed two small tabs on the lower part of the old asm bottom left and right. I used a small screwdriver to release one and then the other tab. I disconnected the electrical connector and the old unit was free. Connect the power plug to the new unit and slide... Read more
Black overflow grille sits below the water and ice dispenser. Replaces cracked, broken, or discolored grilles. 10 inches wide, easy snap-in design.
I replaced the water inlet valve & both dispenser levers (water & ice) and adjusted the lever locking spring. Read more
Fix detergent not dispensing or leaking from your washer's drawer. This dispenser drawer assembly replaces cracked or warped drawers. Simple installation.
Ice maker not filling properly or water leaking in freezer? A cracked fill cup causes inconsistent fills and leaks. Simple DIY fix guides water correctly.
I SAW THE VIDEO AND WAS SO EASY THAT MY CHILDREN COULD DO IT Read more
Channels ice from maker to dispenser opening. Replace if cracked, broken, or missing to prevent ice scatter and jams. Installs in freezer door dispenser.
Identified and ordered part Read more
Fix dispenser door that won't latch or leaks at the door bottom. This grommet and latch kit stops water leaks. Requires inner door panel removal.
The grommet was old and very caked with old dishwasher scum. So water was leaking through where the soap door latch goes into the door. I replaced the rubber grommet (and the plastic latch that came with the kit, even though the old one was probably fine). Fit perfectly and looked just like the old one. Works like a champ, no leaking! Read more
Fix rinse aid that won't flow or dispense properly. This dishwasher rinse aid dispenser cap replaces a clogged or damaged unit to restore proper filling.
Actuates the ice dispenser chute flap to open and close during dispensing. Replace if the door won't move, stays open, or fails to seal the chute properly.
I replaced the ice door motor with new hardware, circuit board on touch panel display then the main ECB on top in the doghouse. It finally came to life and started working! No issues with the front panel and everything works as it did! Read more
Fix a detergent dispenser door that won't close or latch properly. This assembly restores proper soap release timing. DIY repair in 20-30 minutes.
I bought a new one and installed it. I had to buy a set of small Torx drivers to remove screws holding front panel. Wish I'd known to have very small hex wrench to remove 6 screws holding soap dispenser. It was also quite a juggling act to hold the front panel on the dishwasher door steady and put the screws back in. However, the new dispenser works perfectly! Read more