Microwave Parts

Ordered the left and right latch, took off the trim ring, unscrewed the door face and removed it, replaced the latches and I was done! The reason these parts are so expensive is because they are METAL, not the cheap original plastic. Read more

Replaced the Humidity sensor, Thermistor and door switches. I replaced these thinking the problem was one of the items but didn't want to trial and error one part at a time. Plus the cost was reasonable so if these didn't help I wasn't out a lot of money. I sense the door switch was the problem. Replaced all items and the microwave works great. Thanks for the advice and the cost of the parts. Read more

Bought these two pieces through Appliance Parts Pro - they matched exactly at half the cost. Shipped same day. Read more

Replaced it. The instructions did not come with the Handle and a picture I had of the parts did not tell me. I used a putty knife to removed the ring around the door and once that was off could see where the rest of the door was held in with snaps. Using the putty knife again I moved the rest of the door, to expose the handle. Unscrew the screws holding the handle placed the new one on and re-screwed it. Snapped the inter door back on and than added the frame trim back on. Putting it back... Read more

I ordered a new magnetron and a new capacitor and after they arrived I set to work. I took plenty of pictures with my phone to remind me how the components came apart but it was pretty straight forward. Once the new parts were in and everything was reassembled the microwave worked good as new. The repair was less than a third the cost of replacement and no special tools are required. Just be careful to discharge the capacitor. This website is a great resource. Read more

I ordered a gadget with wheels on it to put under the little plate. now the little plate goes around in circles. Read more

Simply removed the melted cover and fan assembly, replaced with new parts. Took about 60 seconds! Read more

• broken bulb

Our microwave is mounted over the range, and has dual lights underneath that light up the range. A while back in trying to replace burned out bulbs, one of the bulbs broke and in trying to remove the rest of the bulb from the socket, I accidentally destroyed the socket. We worked fine with the remaining bulb for a year or so, but it finally burned out. Unfortunately all of the replacement bulbs would only last 1-2 days before burning out again in the one socket. When I'd originally destroyed... Read more

Bought the installation kit above with all the hardware and screws needed to install. About half the price as the manufacturer. Read more

Ordered the trays from Appliance Parts Pros. Read more

Pulled the old cover off, and snapped in the new one. Couldn't figure out how to disengage the locking tabs on the old one, so ended up just breaking them off (they're not large or strong). Read more

I received the parts from parts pro within 3 days and everything fit perfectly nd all went well Thanks Parts Pro Wayne Mazur Joliet Il Read more

Replaced all three door switches and bracket. It had a break in it. Took less than an hour to fix once all parts arrived. Read more

Unplug your microwave. Took the screws off of the bottom of the unit with it still on the cabinet. The whole bottom panel swung down to expose the turntable motor. I took the power cable loose (just pull it off). It was one screw to take the motor out. Word to the wise: DON'T try to take the plastic coupler off before the motor. Their is a tab that holds it in while the motor is in place. If you pry it up you will break it, trust me. ;) Turn the motor out of its housing and it come right out.... Read more

This part was an exact replacement. I removed the door and took out the old part and replaced it with the new one. Getting the door off was the hardest part. Read more