Range / Cooktop / Oven Switch
Bestselling
Price High to Low
Price Low to High
By: Frigidaire
Part Number: 316498603
Burner won't heat or stays on constantly? This range burner control switch regulates cooktop element temperature. Straightforward DIY fix.
Do-It-Yourself Stories from Customers like You
The burner control switch was broken! Rinuan W. • San Francisco , CA • November 19, 2024
I ordered a new one and replaced it!
Read more
More
$69.75
Compare At:
$82.30
You Save:
$12.55
By: Whirlpool
Part Number: WPW10215034
Fixes dual burner stuck on high, won't heat, or no inner ring control. This infinite switch restores precise temperature selection. 45-60 minute DIY repair.
Do-It-Yourself Stories from Customers like You
Burner didn't turn on Bruce H. • Granger , IN • August 18, 2015
I replaced both the element and the switch. It was a relatively easy fix, although I needed a second set of hands to hold the stovetop upright while I did the replacement. The entire job took about 45-60 minutes.
Read more
More
$161.78
Compare At:
$190.90
You Save:
$29.12
By: Whirlpool
Part Number: WP74011243
Burner stuck on high or won't heat? The infinite switch controls surface element power from low to high. Common DIY fix restores heat adjustment.
Do-It-Yourself Stories from Customers like You
No control of range burner burner was either off or on high no heat adjustment Robert B. • Toms River , NJ • September 06, 2014
Replaced infinite switch
Read more
More
$73.95
Compare At:
$88.74
You Save:
$14.79
By: Whirlpool
Part Number: 12002121
If your cooktop burner only works on high or won't adjust temperature, the infinite switch likely failed. DIY-friendly repair in under 30 minutes.
Do-It-Yourself Stories from Customers like You
Right front double burner only worked on high!!!! Rolland F. • Brasher Falls , NY • September 21, 2014
Ordered the part and a few days later it arrived and I turned off the power and took a few screws out and unpluged the old one and pluged in the new .. Works like a charm.. Was very easy to fix....
Read more
More
$79.74
Compare At:
$94.09
You Save:
$14.35
By: Ge
Part Number: WB24K10068
This plunger switch is the push-style electrical switch that completes a circuit when an actuator is depressed, restoring reliable on/off signaling. Use it to replace a worn or broken plunger switch that causes intermittent or non-responsive operation. What it does:
Closes an electrical circuit when the plunger is pushed, sending a signal to the appliance control. Commonly used where a door, lever or dispenser actuator must register a position or user input. Can correct symptoms like intermittent operation, a dispenser or mechanism that won't activate, or a stuck/unresponsive actuator. Acts as a direct mechanical-to-electrical interface—no electronics required. What's included: One plunger switch. Install notes:
Disconnect power (unplug or turn off breaker) before servicing to avoid shock. Remove the access panel or housing to reach the switch; note actuator orientation before removal. Disconnect terminals or harness, then swap the old switch for the new one; reconnect terminals securely. Test the plunger action and appliance function before reinstalling panels.
Do-It-Yourself Stories from Customers like You
Light was stuck on because switch was bad Brian F. • Clinton , NY • October 10, 2015
I pulled the switch out of the oven console and wiggled it until it started working. That only worked for a few days. I ordered the new switch from AppliancePartsPros on Monday. In the mean time, I pulled the switch off and held the wiring harness in place with duct tape. This turned off the light. Two days later, I plugged in the replacement switch, pushed it into the console and the rest is history! Thank you AppliancePartsPros!
Read more
More
$14.95
Compare At:
$17.64
You Save:
$2.69
By: Frigidaire
Part Number: 318293818
If your cooktop burner won't heat, stays on high, or won't turn off, a faulty burner control switch is often the cause. DIY repair in 15-30 minutes.
Do-It-Yourself Stories from Customers like You
Failure of switch/controller on stove top. William S. • League City , TX • March 19, 2024
Ordered the switch from AppliancePartsPros.com and received promptly.
Read more
More
$67.95
Compare At:
$81.54
You Save:
$13.59
By: Frigidaire
Part Number: 808136601
This is a door-activated switch that detects whether the oven door is open or closed. It controls functions such as the oven light or signals the control board about door position. Replace this switch if the oven light stays on or off regardless of door position, or if the oven does not operate correctly due to a faulty door signal.
Do-It-Yourself Stories from Customers like You
Oven light would never turn off. Raul R. • Northlake , IL • March 15, 2018
Bought a door light switch from your company and used it to replace the bad one from my stove.
Read more
More
$52.46
Compare At:
$62.43
You Save:
$9.97
By: Whirlpool
Part Number: WP9757262
Oven light not turning on when door opens? This door-activated switch detects door position and controls interior lighting. Easy push-in installation.
More
$76.79
Compare At:
$91.38
You Save:
$14.59
By: Whirlpool
Part Number: 12002790
Burners won't spark or ignite? This igniter switch assembly restores reliable ignition to gas burners. Most DIYers complete this repair in 20-30 minutes.
Do-It-Yourself Stories from Customers like You
Continuous sparking and then a fire Richard B. • San Dimas , CA • March 04, 2017
A few weeks back, when shutting off a burner, the igniter started sparking and wouldn't stop. Working the knobs and jiggling them got it to stop. Fast forward a few weeks. Finish cooking, go sit down to eat. Hear snapping noise, go look, see burners are all off and the igniters are all sparking. Jiggle the knobs. Poof! Flames come out the top one! What a stink. Unplugged stove, finished dinner. Loosened the cooktop and investigated. Ordered switch. Two days later, part arrives. Two screws...
Read more
More
$102.32
Compare At:
$121.76
You Save:
$19.44
By: Whirlpool
Part Number: 12002791
Burner won't spark or click when turned to Lite? This igniter switch mounts on the gas valve to signal the spark module. DIY fix in under 30 minutes.
Do-It-Yourself Stories from Customers like You
Cleaning stove top fried ignitors opn maytag gas double oven/stove Rainer F. • Gloversville , NY • August 15, 2016
Ordered ignitor harness and two burners (Holder/Orifice) and with supplied videos spent about 40 minutes exchanging parts - saved roughly $500.
Must say, great parts (look original), good price, easy web site and, most of all, helpful video!
Read more
More
$102.32
Compare At:
$121.76
You Save:
$19.44
By: Frigidaire
Part Number: 318293820
Fix a burner stuck on high or not heating with this surface element switch. Controls power to your cooktop heating element. DIY-friendly repair.
Do-It-Yourself Stories from Customers like You
Large burners would go to high when turned on Charles H. • Prestonsburg , KY • October 25, 2016
Replaced infinite switch on large burners and just went ahead and replaced the infinite switch on the small burners while I had it apart and installed all new surface elements as well...parts were shipped the next day and I received them within 2 days...
Read more
More
$64.70
Compare At:
$76.99
You Save:
$12.29
By: Frigidaire
Part Number: A00056506
This switch assembly restores electrical on/off control for a specific appliance function. Replace a worn or failed switch to stop intermittent operation and return reliable control to the affected circuit. What it does:
Provides the electrical on/off or function control for the appliance circuit. Replaces a failed switch that can cause intermittent operation or unresponsive controls. Helps resolve symptoms such as a function that won't start, no response from the control, or erratic switching. Connects to the existing wiring harness and mates with the original mounting points. What's included: One switch assembly. Install notes:
Disconnect power to the appliance before beginning any work. Remove the appropriate access panel to reach the switch; note wire and terminal locations before disconnecting. Unplug the wiring harness or carefully detach terminals, swap the switch assembly, then reconnect securely. Restore power and verify the replaced switch operates the function correctly.
More
$28.95
Compare At:
$34.45
You Save:
$5.50
By: Whirlpool
Part Number: WP3148955
Fix a burner that won't turn off, stays on high, or won't heat. This infinite switch restores precise temperature control for electric cooktop elements.
Do-It-Yourself Stories from Customers like You
Electric burner control switch William F. • Teutopolis , IL • March 08, 2017
Turn the power off to the range. Pull off the black control knob. Remove 6 - 5/16 screws in back of the range behind the controls panel. Take out 2 screws (behind the control knob) in front that hold the control swirch in the panel. Remove each wire from the old switch and place it onto the new switch (one at a time)so get the wires are installed in the correct place. Make sure the wire are tight on the new switch. Install the new switch, put the two mounting screws in, reinstall the back, put...
Read more
More
$87.60
Compare At:
$105.12
You Save:
$17.52
By: Whirlpool
Part Number: WP74007806
Fix burners that won't light with this cooktop igniter switch wire assembly. Restores reliable spark ignition when switches fail. Moderate DIY repair.
Do-It-Yourself Stories from Customers like You
Three out of 5 igniter switches wouldn't work Marcus B. • Eads , TN • February 11, 2017
Replaced igniter switch harness
Read more
More
$102.35
Compare At:
$121.80
You Save:
$19.45
By: Bosch
Part Number: 00622858
If your oven won't start or runs with the door open, this door interlock switch detects proper closure and latching. DIY repair in under an hour.
Do-It-Yourself Stories from Customers like You
Broil element had gone bad due to age and use Sherwood O. • Orange , CA • August 22, 2015
This turned out to be a very complicated repair ONLY because the wires that attached to the very far end of the broil element came detached inside and behind the wall of the oven. It is one step this side of impossible to fish the wires out and reconnect them to the new element.
This would be a very easy job PROVIDED that you do not allow the two wires that connect to the element to become detached inside the rear oven wall.
Read more
More
$31.43
Compare At:
$37.09
You Save:
$5.66
By: Bosch
Part Number: 00624610
This rotary potentiometer converts shaft rotation into an electrical signal the control board can read, providing precise position feedback for user selections. Replace it if inputs become erratic, jump between settings, or the control stops responding.
Provides rotary position feedback to the electronic control Enables accurate selection and adjustment of functions or setpoints Wear or damage can cause drifting, dead spots, or incorrect readings Intermittent or no response to input is a common failure symptom What's included: 1 potentiometer Install notes:
Disconnect power before servicing Access the control/console area to reach the component Note shaft orientation and any connector positions; transfer exactly to the new part Handle electronics with ESD care and verify smooth, full-range operation after reassembly
More
$111.95
Compare At:
$134.34
You Save:
$22.39