Refrigerator Gasket & Seal

Removed old seal, installed new seal, used heat gun to expand new seal slightly for good fit. Coated with vaseline. Perfect fit. Easy installation. Read more

I ordered new gaskets and swapped out the old ones. Read more

Replaced the door seal I will not know for 2to3 weeks if that fix it or not Read more

Really simple fix no tools required. Simply pulled the old out and install the new one in . Not hard at all. Read more

Pulled out old parts, and swapped with new. New seals needed to be warmed up with a hair dryer to get wrinkles out from shipping, but that was simple as well. With my fridge, there was also a secondary piece on the door which needed to be removed with a screw. Took some extra time to give all those surfaces on the fridge a much needed cleaning while the seals were off. New seals fit perfectly and the replacement was simple- video provided on the website was also helpful. Read more

• Door sweating
• Fridge runs too long

Loosened nuts around outer flange. Pulled out old gasket as shown in video. Prepared new gasket per included instructions. Installed new gasket again using techniques shown in video. Secured nuts then confirmed proper seal. This was not a difficult repair however patience and care is needed to ensure new gasket is properly seated without damage. Read more

Took out the old gaskets put the 2 new ones in and it was all a simple project. Couldn't be easier. Read more

First I ordered a new ice door seal, spring, and crank, figuring the condensation in freezer and door was caused by ice door not sealing. Turns out the solenoid for the ice door was completely rusted and was the primary cause, if it had been replaced early, it would have saved the dispenser board. What then happened was the moisture in the freezer door damaged the control board rendering dispenser controls inoperative as well as the heater around the dispenser. Now the freezer door is dripping... Read more

Since the fridge was an older model, it had screws behind the gaskets. First, I removed the freezer door, then I loosened the screws and removed the old gasket. I then placed the new gaskets, corner first, then worked my way around the door until all sides was done. I tightened the screws. For the lower door, I didn't remove the door but I removed all items from the door shelves. Loosened the screws, removed the old gasket, then placed the new gasket one corner and worked my way around the... Read more

• Freezer section too warm

It was bad at all I was able to get it done in about 1 1/2 I had to unscrew the nuts and place new gasket and the place new gasket and put back the nuts Read more

• Door sweating

I called Appliance Parts Pros and gave them the model number of my refrigerator. They promptly advised me exactly what part I needed, told me the price and cost of shipping. I agreed and received my part within 2 days. I watched the video that told me exactly how to complete repair. It was very simple. The only thing different was that there was a metal strip holding the gasket in place. Removing it was no problem. When I installed it I had to loosen the screws? nuts? slip the gasket... Read more