Tube Or Fitting

Gas supply tube for cooktops. Connects gas source to burner assembly. Replace if cracked, kinked, damaged, or leaking to restore safe gas flow.

Vent tube that routes hot air and moisture from the oven cavity to the exterior. Replace if cracked, corroded, or disconnected to restore proper ventilation.

Burner tubing for left front and rear burners on gas cooktops. Replace if cracked, damaged, or leaking. Connects gas valve to burner assembly.

Gas valve tubing for gas cooktops. Connects gas valve to burner assembly. Replace if cracked, kinked, leaking, or damaged to restore safe gas flow.

Connects the pilot flame to the thermostat in gas ranges. Replace if tube is kinked, cracked, or damaged, preventing proper heat sensing and regulation.

Connects tubing sections to service plumbing ports on your range. Replace if the original fitting is cracked, broken, or leaking to restore a secure seal.

Metal gas supply tube that connects gas valve to burners or oven. Replace if tube is kinked, cracked, corroded, or leaking to restore safe fuel routing.

This gas tubing is the direct-fit replacement part that routes natural or liquid propane gas between range components, restoring safe fuel flow for proper burner operation. It replaces worn or damaged tubing without modifying factory connections. What it does:

• Carries gas from the valve to burners or manifold to enable ignition and normal burner flames
• Commonly replaced when tubing is corroded, cracked, kinked or leaking
• Can stop symptoms such as persistent gas smell, burner failure to light, or intermittent flame
• Matches OEM fit and connection locations for a straightforward swap

• One gas tubing

• Shut off the gas supply and disconnect power before starting any work
• Only install on compatible appliances; use approved fittings and follow torque specs from the appliance manufacturer
• Check all connections for leaks after installation using a soapy-water solution or approved gas leak detector

Gas supply tube for gas ranges. Connects gas valve to burner manifold. Replace if cracked, damaged, or leaking. Essential structural component.

Replace the left front burner tube on your range. Needed when the tube is cracked, corroded, or damaged, preventing proper gas flow to the burner head.

Burner tube assembly for gas ranges. Connects burner to gas supply valve. Replace if cracked, damaged, or leaking to restore safe operation.

This 7/16-inch gas supply tube connects the gas valve to the burner assembly in your cooktop. Replace if cracked, damaged, or leaking to restore safe operation.

Gas tube fitting for cooktop burner systems. Connects gas supply lines. Replace if cracked, damaged, or leaking. 7/16 inch diameter tube fitting.

This burner tube connects gas supply to your range burner assembly. Replace if cracked, corroded, or damaged to restore proper gas flow and prevent leaks.

This tubing is the OEM thermo/safet capillary line used with the temperature sensing/thermal safety assembly. It transfers temperature information to the control so the appliance can maintain proper temperature and protect components. What it does

• Carries temperature feedback from the sensing bulb to the thermostat/thermal safety device
• Allows the control to react to temperature changes and open/close circuits as designed
• A damaged or kinked tube can cause inaccurate temperature sensing or control faults
• Common symptom: temperature not regulated or unit cycling irregularly when sensing line is compromised

• One thermo/safet tubing

• Install only if tubing and fittings match the original; avoid sharp bends or kinks in the line
• Handle the sensing bulb and capillary gently to prevent damage
• Disconnect power before attempting service; follow all safety and grounding procedures