Washer Cap Or Cover

This rear cover is the outer housing panel that protects the appliance's internal components and helps maintain proper airflow and support. It replaces a cracked, broken, or missing rear housing panel to restore protection and fit. What it does:

• Shields motors, wiring, vents, and other internal parts from dust, debris, and accidental contact
• Helps direct airflow and maintain correct ventilation for safe operation
• Restores proper mounting points and prevents rattles from a loose or damaged back panel
• Commonly replaced when there is visible damage, missing mounting tabs, or unusual noise from the rear

• One rear cover

• Disconnect power (unplug or switch off circuit breaker) before starting any repair
• Removal usually requires taking off the exterior panels and a few screws or clips; retain all fasteners for reinstallation
• Watch for sharp edges and wear protective gloves; handle internal wiring and components gently

This bleach cover is the replacement lid for the washer bleach dispenser, keeping the bleach compartment closed and preventing spills while the washer fills. It helps direct bleach into the wash and keeps the dispenser clean. What it does:

• Covers the bleach dispenser to prevent accidental spills and splashes
• Helps ensure bleach flows into the tub at the correct time during the fill cycle
• Prevents debris from entering the bleach compartment
• Replaces cracked, broken or missing covers that can cause leakage or uneven dispensing

• Turn off and unplug the appliance before servicing to avoid injury
• Remove any clothing or leftover detergent from the dispenser area before replacing the cover
• Most replacements snap or clip into place; align carefully to avoid damaging surrounding parts

This cover is a replacement access panel that protects internal components and helps maintain appliance appearance. It restores the appliance's finished look and keeps wiring and parts shielded from debris. What it does:

• Shields internal components and wiring from dust, moisture, and accidental contact
• Restores the appliance's exterior appearance after service or damage
• Helps maintain proper airflow routing around covered components
• Useful when replacing or servicing internal modules that require a protective panel

• Remove power to the appliance before attempting installation to avoid shock or injury
• Installation typically requires removing nearby trim or fasteners; keep screws and clips for reuse
• Handle carefully to avoid scratching the finish or bending mounting tabs
• If mounting holes or clips don't align, recheck part number.

This duct outlet directs dryer exhaust from the appliance to the home vent, helping maintain proper airflow and a finished connection. It replaces damaged or cracked outlets that can cause leaks, rattles, or restricted airflow. What it does:

• Provides a secure discharge path for exhaust air from the appliance
• Restores a sealed connection to the vent system to reduce leaks and lint escape
• Replaces cracked, warped, or broken outlet pieces that cause rattling or poor airflow
• Helps prevent airflow restriction that can extend drying times or stress the dryer

• Disconnect power and gas before servicing the dryer
• Work in a well-lit area and note existing vent/clamp orientation before removal
• Use gloves to protect hands from sharp sheet-metal edges
• Check and tighten clamps or seals after installation; replace any damaged vent hose or hardware

This outer housing case protects internal components and provides the appliance's external structure for reliable operation and a finished appearance. It helps keep parts aligned and shields electronics and mechanisms from debris and damage. What it does:

• Covers and protects internal components from dust and accidental contact
• Keeps internal modules properly positioned and supported
• Restores the appliance's exterior appearance and structural integrity
• Stops rattles or vibrations caused by a damaged or missing panel

• One outer housing case

• Disconnect power and water before beginning any repair
• Handle panel edges carefully to avoid cuts or cosmetic damage
• Use manufacturer-recommended fasteners; do not overtighten screws