Washer Door, Door Glass & Parts

This inner oven door window provides the clear, heat-resistant viewing panel that lets you monitor cooking without opening the door. Replacing damaged or cloudy glass restores safe visibility and helps maintain oven temperature. What it does:

• Serves as the interior viewing glass for the oven door
• Keeps heat contained while allowing you to see inside the oven cavity
• Commonly replaced for cracks, chips, fogging, or shattered glass
• Helps reduce heat loss from a damaged or broken door panel

• One inner oven door window

• Disconnect power to the appliance before starting any repair
• Allow the oven and door to cool completely; wear cut-resistant gloves and eye protection when handling glass
• Removal may require partially disassembling the oven door and carefully detaching retaining clips or screws

This inner door ring secures the door glass and surrounding trim for compatible GE front-load washer/dryer doors, restoring a secure fit and helping the door close and seal correctly. It replaces a cracked, broken, or missing inner door ring. What it does

• Holds the inner door glass and trim in place to maintain door alignment and appearance
• Prevents rattling or movement of the door glass during operation
• Helps the door seat properly to reduce gaps that can cause leaks or drafts
• Restores a finished look when the original ring is scratched, cracked, or damaged

• One inner door ring

• Disconnect power before starting any repair to prevent shock or injury
• Remove the door assembly or inner trim as needed to access fasteners; keep track of screws and clips
• Use appropriate hand tools and a non-marring surface to avoid scratching the glass or door finish
• Inspect door glass and outer trim for damage while replacing the ring; replace any damaged components for proper fit and sealing

This cover door is an access panel that restores the appliance's exterior finish and protects internal components from dust and debris. It provides a secure, finished closure for the service opening. What it does

• Covers and protects internal components behind the service opening
• Allows controlled access for servicing when removed
• Prevents debris, lint, or small objects from entering internal areas
• Stops rattling or loose-fit noise caused by a damaged or missing panel
• Restores the appliance's finished appearance and safe closure

• One cover door

• Disconnect power (and fuel supply if applicable) before servicing
• Installation typically requires basic hand tools (screwdriver); keep fasteners for reassembly
• Handle edges carefully; wear gloves to avoid cuts on metal parts
• If alignment or fit is poor after installation, check mounting points and fastener torque

Replace a cracked or cloudy door window with this outer lens. It forms the transparent exterior panel of the door, protecting the inner window and restoring a clean look and clear view into the drum during cycles.

• Forms the exterior, see-through panel of the door window
• Shields the inner window and helps the door close evenly against its trim
• Replace if the outer window is cracked, chipped, warped, loose, or discolored/cloudy
• Damage may cause poor visibility or sharp edges around the door opening

• Disconnect power before servicing the appliance
• Remove the door and place it on a padded surface
• Separate inner/outer door panels, note screw locations, and lift out the old lens
• Clean mating surfaces; set the new lens in place and reassemble without over-tightening screws

The Outside Door Panel replaces a cracked or broken outer trim on your washer door. It restores appearance and alignment, supporting the door glass and handle so the door latches correctly and cycles can start.

• Forms the exterior frame/trim and handle area of the washer door
• Supports and positions the door glass while aligning with the hinge and latch
• Helps ensure the door closes properly to allow a cycle to begin
• Typical symptoms: cracked/broken trim, loose or misaligned door, difficulty opening/closing

• Disconnect power; turn off water supplies before servicing
• Open the door and support the assembly; remove perimeter screws securing the outer to the inner door panel
• Transfer door glass, handle components, and any reusable hardware from the old panel to the new one
• Reassemble and tighten screws evenly; verify smooth operation and proper latching before use