Washer Dryer Combo Bracket & Flange

This dryer bearing bracket secures the drum's rear bearing to keep the drum aligned and rotating smoothly. Replacing a worn bracket can help reduce drum wobble, scraping noises, and uneven drum rotation. What it does:

• Supports and locates the rear drum bearing to maintain proper drum alignment.
• Helps prevent the drum from wobbling, rubbing, or scraping against the cabinet.
• Can reduce or eliminate grinding, squealing, or thumping noises caused by a loose or damaged rear support.
• Works with the dryer's rear bearing assembly to enable consistent drum rotation.

• Disconnect electrical power (and gas, if applicable) before beginning any repair.
• Access typically requires removing the dryer drum and rear bulkhead.
• Inspect the bearing, shaft, and surrounding glides; replace any worn components to prevent repeat failure.

This hinge bracket secures a refrigerator door hinge to the cabinet, restoring proper door alignment and support so the door seals and closes reliably. Designed to replace a worn, bent, or broken hinge mounting bracket. What it does:

• Provides a stable mounting point for the door hinge assembly to prevent sagging or drooping
• Restores correct door alignment to improve sealing and reduce cold air loss
• Stops excess movement or rattling at the hinge area
• Helps eliminate door-binding or uneven gaps that keep the door from closing fully

• Unplug the appliance and remove food/items from the door before starting
• Support the door while removing/installing the bracket to avoid damage or injury
• Reuse or replace fasteners as required; tighten securely but avoid over-torquing
• After installation, check door alignment and gasket seal; make minor adjustments as needed

A replacement pump mounting bracket that secures the appliance drain/pump assembly to the cabinet, restoring proper alignment and reducing movement that can cause noise or leaks. Direct-fit design for correct positioning. What it does:

• Secures the pump/drain assembly to the appliance frame to prevent shifting
• Keeps the pump aligned for reliable water flow and quiet operation
• Helps reduce vibration and rubbing that can cause noise or premature wear
• Supports proper sealing to help prevent water leaks around the pump area

• One pump mounting bracket

• Disconnect power (and water if applicable) before starting any repair
• Basic hand tools are typically required; remove access panels to reach the pump area
• Inspect related fasteners and gaskets; replace any damaged hardware for a secure fit