Washer Dryer Combo Power Nut Or Trunnion
Genuine Frigidaire part
By: Frigidaire
Part Number: 5304466677
This trunnion support fits the appliance's rotating assembly to stabilize and guide the drum or door hinge, restoring proper alignment and smooth operation. Durable replacement designed to match the original mounting points. What it does
- Supports and locates the drum or hinged assembly to prevent wobble and misalignment
- Reduces rubbing, scraping, or grinding noises caused by a worn support
- Helps keep the door/drum tracking true so the appliance opens/closes and spins correctly
- Common symptom: visible sagging, uneven rotation, or unusual noise during operation
What's included
- One (1) support (trunnion) as shown
Install notes
- Disconnect power (and gas if applicable) before servicing; follow all safety precautions
- Remove panels or drum/door per service manual to access the trunnion; retain mounting hardware if reuse is intended
- Inspect adjacent bearings, seals, and mounting tabs for wear and replace as needed
- Test appliance on a short cycle after installation to ensure proper alignment and quiet operation
Do-It-Yourself Stories from Customers like You
Noisy during the washer spin cycle and leaking water John P. • Wasilla , AK • April 16, 2022
The noise turned out to be the bottom bearing between the belt pulley and the transmission. Once apart an easy replacement. But you did need some tools to replace the bearing as in snap ring pliers and bearing puller. The water leak was the top rubber seal which is part of the seal kit. I had to make a puller out of some chain and a 2 jaw-bearing puller to the top of the transmission shaft to get the trunnion off but once it was off the rest was a snap. The video was a big help. Tested the...
Read more
More
$163.32
- Compare At:
-
$192.72
- You Save:
-
$29.40
Out Of Stock
Usually ships within 4 - 14 days
Genuine Ge part
By: Ge
Part Number: WH17X85
$128.95
- Compare At:
-
$157.32
- You Save:
-
$28.37
Out Of Stock
Usually ships within 4 - 14 days
Genuine Frigidaire part
By: Frigidaire
Part Number: 131545101
The trunnion is the hub that mounts the washer's inner tub to the drive shaft. Replacing a worn hub restores a solid, centered connection so the basket spins smoothly without wobble, slip, or grinding. What it does:
- Secures and centers the spin basket on the drive shaft for balanced rotation
- Transfers drive torque to the inner tub during spin
- Helps maintain basket alignment to reduce vibration
- Typical symptoms of failure: loose/wobbly tub, scraping or grinding noises, poor or no spin, frequent out-of-balance events
What's included:
Install notes:
- Disconnect power and water before service; wear gloves and eye protection
- Access the hub by removing top/access parts, then the agitator/wash plate and inner-tub fasteners
- Clean the shaft and mating surfaces; seat the new trunnion fully and tighten fasteners evenly in a crisscross pattern
- Inspect related parts (tub seal, bolts, bearing) while open and replace if worn; run a short test cycle to ensure smooth spin
Do-It-Yourself Stories from Customers like You
Leaking washer tub Hugh S. • Miami , FL • June 25, 2016
The seal at the bottom of the tub had started to fail. On large loads water would leak so I ordered a new one rubber seal. Getting the trunnion off the transmission shaft was hard as it was calcified and corroded. I used a wire brush to get some of it off and then used a lot of WD-40. The bolt holding the trunnion plate on sheared off when I tried to remove it on one side and the other came out ok (the bolt hole through the trunnion is not threaded so it should slide out once the plate is off...
Read more
More
Washer dryer combo Power Nut or Trunnion replacement parts are essential. These parts might not be at the forefront of your mind, but they play a crucial role in the seamless operation of your washer dryer combo. Without them, you'd likely face interruptions that can turn laundry day into a hassle.
A washer dryer combo is an indispensable appliance in many households, offering the convenience of washing and drying in one go. The power nut or trunnion is a small yet vital component that ensures the drum's stable and smooth rotation. By maintaining or replacing these parts, you secure the appliance's overall performance, allowing it to run efficiently and effectively. This means your clothes get reliably cleaned and dried without the risk of unexpected breakdowns.
When looking for washer dryer combo parts, always consider OEM replacement parts to guarantee top-notch quality and perfect compatibility with your machine. These genuine parts are specifically designed for your appliance's make and model, making sure they fit and function just as the original components did. Using OEM parts can give you peace of mind, knowing your appliance will continue to perform at its best.
So, if you need washer dryer combo power nut or trunnion parts, rest assured they are available and made to high standards. Keep that laundry game strong without disruptions by ensuring your machine is always in top shape with the right replacement parts.
More